Page 5 - Table of Contents; Safety Information
Table of Contents Safety Information Important Safety Information - Please Read First i General Safety Information i Reducing Fire Risk i Preventing Oven Damage ii Grounding Instructions ii Power Cord Replacement ii Specifications and Installation Dimensions 1 Electrical Specifications 1 Packaging 2...
Page 7 - Important Safety Information – Please Read First
SAFE T Y INFORM A TION Important Safety Information – Please Read First Improper installation, adjustment, alteration, service, or maintenance of this equipment can cause propertydamage, injury, or death. Thoroughly read the installation, operating, and maintenance instructions beforeinstalling or s...
Page 8 - Preventing Oven Damage; Clean the oven daily.; Grounding Instructions; WARNING: Improper grounding increases the risk of electric shock.; Power Cord Replacement
i i S A F E T Y I N F O R M AT I O N Preventing Oven Damage When servicing this appliance, do not tear insulation to get to components. Rather, find the edge ofthe insulation and remove the tape that holds it in place. Clean the oven daily. Clean the oven only with TurboChef Oven Cleaner. x DO NOT c...
Page 9 - Dimensions; Exterior; Height; Conveyor; Length; Electrical Specifications; North America
SPECIFICA TIONS AND INST ALLA TION 1 Dimensions Exterior Height 13.0” (330 mm) -- with legs 17.0” (432 mm) Width 48.3” (1227 mm) Depth 35.7” (907 mm) Conveyor Length 48.3” (1227 mm) Width (Single) 20.0” (508 mm)Width (50/50) 9.5” / 9.5” (241 mm / 241 mm)Width (70/30) 15” / 4” (381 mm / 102 mm) Elect...
Page 10 - S P E C I F I C AT I O N S A N D I N S TA L L AT I O N; Packaging; Delivery and Initial Inspection
2 S P E C I F I C AT I O N S A N D I N S TA L L AT I O N Packaging All ovens are packaged in a double-wall corrugatedbox with integrated wooden skids. All internationalovens shipped via Air or Less than Container Loadsare packaged in wooden crates. Certifications Oven Construction - 430 stainless st...
Page 11 - Oven Location and Placement; - If the oven is being placed near a grill or stove,; Ventilation Requirements; Figure 6: Installation Near Open Heat Source
SPECIFICA TIONS AND INST ALLA TION 3 Oven Location and Placement WARNING: Death, injury and equipment damage may result from improper positioning. WARNING: DO NOT stack ovens without proper installation of stacking brackets. ContactCustomer Service for more information. WARNING: DO NOT stack ovens m...
Page 12 - C L E A N I N G; Daily Cleaning Instructions; WARNING: DO NOT use a water jet when cleaning the oven.
4 C L E A N I N G = Wash, rinse, sanitize. (Use only TurboChef- approved cleaner, part number 103180). = Completely dry with clean towel. I D LE BACK OFF E M ER GE N C Y S TOP High h Conveyor by TurboChef TM I D LE BACK OFF E M ER GE N C Y S TOP High h Conveyor by TurboChef TM I D LE BACK OFF E M ER...
Page 13 - CLEANING; Step 1: Turn the Oven Off; Weekly Cleaning Instructions
CLEANING 5 WARNING: Always disconnect power before cleaning or servicing oven. I D LE BACK OFF E M ER GE N C Y S TOP High h Conveyor by TurboChef TM I D LE BACK OFF E M ER GE N C Y S TOP High h Conveyor by TurboChef TM I D LE BACK OFF E M ER GE N C Y S TOP High h Conveyor by TurboChef TM COOKING BEL...
Page 15 - Step 5: Replace Oven Components; Step 7: Ready the Oven for Use
CLEANING 7 1. 2. 3. 4. Step 5: Replace Oven Components 1 2 2 1 2 6. 7. 8. 9. 5. Latch Step 7: Ready the Oven for Use 1. 2. Step 6: Verify Chain Tension Acceptable - Chain (A) is tight andeasily clears crumb tray holder (B) A B Call service to have link removed - Chain (A) is loose and risks contact ...
Page 16 - Up and Down Keys; When the oven is in the; up key to access the; the down key to access cooking profiles 5-8.; Oven Controls; The idle key activates the; Emergency Stop Key; damage the oven and shorten its life span.; Figure 7: Oven Controls
8 Oven Controls Figure 7. 1. Display The display shows current oven operation and/oruser programming information. 2. Soft Keys Six soft keys are on the oven controls, three on theleft (L1, L2, L3, where L1 = top) and three on theright (R1, R2, R3, where R1 = top). Use the softkeys to select the opti...
Page 17 - Cooking a Product; Mode 2: Belt Speed Select; Figure 8: Cooking Modes
STAND ARD OVEN OPERA TION Cooking a Product Figure 8. This section explains how to cook a food product bydescribing the “standard operation” modes throughwhich the oven progresses (Figure 6).- MODE 1: Oven Off - MODE 2: Belt Speed Select - MODE 3: Warming - MODE 4: Soaking - MODE 5: Cooking - MODE 6...
Page 18 - S TA N D A R D O V E N O P E R AT I O N
1 0 S TA N D A R D O V E N O P E R AT I O N Mode 3: Warming Mode during which the oven warms to the presetcooking temperature defined by the cooking profilethat was selected. Happens When...- A selection is made from MODE 2, and the oven’s temperature at the beginning of warmup was not within (less ...
Page 19 - Editing a Cooking Profile; Edit Options Screen; Changing a Cooking Profile Name
STAND ARD OVEN OPERA TION 1 1 Editing a Cooking Profile To edit a cooking profile, the oven must be in the COOKING MODE and the full edit or flex option must be enabled for each option to be edited. Formore information on selecting between full edit,rigid, and flex options for each editable setting,...
Page 20 - Adjusting the Belt Speed
1 2 S TA N D A R D O V E N O P E R AT I O N BELT R10:00 TOP AIR 80 % <--- ---> PROFILE 1 Adjusting the Belt Speed The High h Conveyor Oven can accommodate either one or two conveyor belts. The oven will automatically detect the number of conveyor beltsinstalled and display the option to change...
Page 21 - OVEN MODES; Config Mode; Accessing the Fault Count Screen; Setup Mode; CONFIG MENU
OVEN MODES Config Mode The CONFIG MODE (Figure 11) serves four main purposes: 1. To access the smart card screen.2. To access the fault count screen.3. To access the SETUP MODE . 4. To access the TEST MODE (service use only). To access the CONFIG MODE , press the up key from the OVEN OFF MODE . Smar...
Page 22 - Changing the Display Temperature; Changing the Display Language; FAULT COUNTS
1 4 EC=82F 208V RUN: 65432 HRIDLE: 12345 HR INFO SERIAL_NUMBER SOFTWARE VERSION Figure 19: Info Screen DEGS F EDIT/RIGID/FLEX ENGLISH SETUP MENU INFO Figure 16: Setup Mode Changing the Display Temperature The oven can display the temperature in either Celsiusor Fahrenheit units. To change the displa...
Page 23 - Updating the Firmware; Please note that the
1 5 OVEN MODES Updating the Firmware From the oven off screen, 1. Insert the gray smart card (see Figure 13, page 13) with the gold chip facing the front of the oven. If multiple smart cards are required, they will be labeled in sequence - ensure the correct sequence is followed. 2. From the COOLING...
Page 24 - T R O U B L E S H O O T I N G; Issue
1 6 T R O U B L E S H O O T I N G Issue Possible Cause(s) Resolution No power to oven. - Oven is not plugged in. - Main circuit breaker is tripped. - Plug oven in. - Verify wall circuit breaker is on. Reset breaker and then power oven back on. Oven is not warm-ing up properly. - Oven is in the off s...
Page 26 - Replaceable Parts; Part Description
1 8 T R O U B L E S H O O T I N G Replaceable Parts The following is a list of parts that may need replacing during the life of the oven. For more information,please contact TurboChef. (Within North America, call 800.90 TURBO . Outside North America, call +1 214.379.6000 or your authorized distribut...
Page 27 - North America Limited Warranty; TurboChef “HhC 2020” Conveyor Oven – North America
NOR TH AMERICA LIMITED W ARRANT Y 1 9 North America Limited Warranty TurboChef “HhC 2020” Conveyor Oven – North America The TurboChef HhC 2020 Conveyor oven Limited Warranty outlined below is activated upon shipment ofyour oven. Should you require additional assistance after reviewing the warranty o...
Page 28 - N O R T H A M E R I C A L I M I T E D W A R R A N T Y; Outstanding Invoices:
2 0 N O R T H A M E R I C A L I M I T E D W A R R A N T Y Modifications and Repair: Equipment that has been modified or altered by persons other than TurboChef or itsservice agents, or Equipment that has had non-approved devices or connection items attached thereto, isexcluded from coverage under th...
Page 29 - Disclaimer of Damages
NOR TH AMERICA LIMITED W ARRANT Y 2 1 net 10 days. Customer also agrees to pay any cost incurred by TurboChef or its service agent associated witha service agent responding to a call for service, but then being refused or unable to gain access to the Ovenon Customer’s premises. Failure to submit pay...
Page 30 - I N T E R N AT I O N A L L I M I T E D W A R R A N T Y; Limited Warranty; International Limited Warranty
2 2 I N T E R N AT I O N A L L I M I T E D W A R R A N T Y This Limited Warranty shall apply to the sales of all TurboChef HhC 2020 Conveyor ovens (the“Equipment”) manufactured by TurboChef Technologies, Inc. (“TurboChef ”), and sold to purchasers outside of the United States, Canada, and Puerto Ric...
Page 31 - Warranty Service
INTERNA TIONAL LIMITED W ARRANT Y 2 3 Warranty Service During the Warranty Period, any materially defective Equipment will be repaired or replaced free of chargeat TurboChef ’s option provided that:1. You notify the Authorized Distributor from whom You purchased the Equipment and/or TurboChef as soo...
Page 32 - Consumables and Parts Used with The Equipment:
2 4 I N T E R N AT I O N A L L I M I T E D W A R R A N T Y The claim must include the serial number of the Equipment and be received by TurboChef on or before thelast day of the Warranty Period. Upon receipt of Your claim, TurboChef will promptly notify an AuthorizedDistributor or an authorized serv...
Page 33 - waiver of such default or a waiver of any other default.
INTERNA TIONAL LIMITED W ARRANT Y Governing Law, Entire, Agreement: This Limited Warranty shall be governed by and construed according to English law. The application of the United Nations Convention on International Sale of Goods to thisLimited Warranty is expressly excluded. This Limited Warranty ...
Page 34 - For service or information:; Customer Service; T U R B O; or
Accelerating the World of Cooking TM Corporate Headquarters Six Concourse Parkway, Suite 1 9 0 0 Atlanta, Georgia 3 0 3 2 8 U S A + 1 6 7 8 . 9 8 7 . 1 7 0 0 P H O N E + 1 6 7 8 . 9 8 7 . 1 7 5 0 FA X Sales & Marketing : 866.90 T U R B O Global Operations 4 2 4 0 I n t e r n a t i o n a l P k w ...
