Page 2 - Welcome to the world of Electrolux; you with lots of pleasure in the future.
2 Welcome to the world of Electrolux Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable. You find some examples...
Page 3 - Contents; Guide to Use the instructions; Safety Instructions
3 Contents Important Safety Information .................................................................................. 4 Instructions for the User .......................................................................................... 8 Description of the Hobs ...................................
Page 4 - Important Safety Information; Installation
4 Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950 Installation This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Install...
Page 5 - Service; only genuine approved spare parts should be used.; Environmental Information; The symbol
5 Ensure the control knobs are in the ‘OFF’ position when not in use.When using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance.Unstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by t...
Page 6 - Description of the Hob
6 1. Hob Top 2. Semi-rapid Burner 3. Triple Crown Burner 4. Rapid Burner 5. Auxiliary Burner 6-10 Control Knobs Description of the Hob 2 1 2 4 5 6 7 8 9 3 10
Page 7 - and in accordance with existing rules and regulations.; in the event of a breakdown.; which were put on in the factory.
7 INSTALLATION Any gas installation must be carried out by a registered competent person, and in accordance with existing rules and regulations. The relevant instructions are to be found in the second section of this manual.Please, ensure that, once the hob is installed, it is easily accessible for ...
Page 8 - Operation; Hob burners control knobs; The symbols on the knobs mean that :; Lighting the burners; flat
8 Operation Hob burners control knobs The symbols on the knobs mean that : there is no gas supply there is maximum gas supply there is minimum gas supply Lighting the burners For easier lighting, proceed before putting a pan on the pan support. To light a burner:push in the relevant control knob and...
Page 10 - Before any maintenance or cleaning can be carried out, you must; The Hob Top; are centred upon the burner as shown in the picture.; Maintenance and Cleaning
10 Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply.The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.This appliance cannot be cleaned with steam or with a steam cleaning ma...
Page 12 - Something Not Working?; SYMPTOM
12 Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM There is no spark when lighting the gas. The gas ring burns unevenly. SOLUTION Check that the unit is plugged in and the electrical supply i...
Page 13 - Instructions for the Installer; Engineer technical data
13 OVERALL DIMENSIONS Width: 680 mm Depth: 510 mm Height: 72 mm CUT OUT DIMENSIONS Width: 560 mm Depth: 480 mm Thickness: 30 mm SUPPLY CONNECTIONSGas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V ~ 50 Hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp ...
Page 15 - Important safety requirements; Location
15 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S....
Page 16 - IMPORTANT; parts together without using excessive force.
16 CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE CLEARANCES REQUIRED WHEN FITTING THE GAS HOB WITH A COOKER HOOD ABOVE Installation IMPORTANT This hob must be installed by a competent person to the relevant Gas Standards.Any gas installation must be carried out by a regist...
Page 17 - Gas Connection
17 It is important to install the elbow correctly, with the shoulder on the end of thethread, fitted to the hob connecting pipe. Failure to ensure the correct assembly will cause leakage of gas. Gas Connection Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel or...
Page 18 - Cut Out Size; The dimensions of the cut-out are given in the diagram.
18 Cut Out Size The dimensions of the cut-out are given in the diagram. 560 480 30 150 min
Page 19 - Dimensions are given in mm.; Building over a cupboard or drawer; Building In
19 ON/OFF SWITCH FLEXOUTLET 2 Building over a kitchen unit withdoor Proper arrangements must be taken in designing thefurniture unit, in order to avoid any contact with the bottomof the hob which can be heated when it is operated. Therecommended solution is shown in diagram 3. The panel fitted under...
Page 20 - Fitting the Hob into the Worktop; Seal
20 Fitting the Hob into the Worktop Carry out the building in of the hob as follows: 1. place the seals supplied with the hob on the front edge of the cut out. Then, place them at 50 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet with...
Page 21 - Electrical Connections
21 Electrical Connections Any electrical work required to install this hob should be carried out by a qualified electrician or competent person, in accordance with the current regulations.THIS HOB MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed.T...
Page 22 - Wiring Diagram; Permanent Connection
22 Wiring Diagram 2 1 L N 0 220240 1 2 3 4 5 N Permanent Connection In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the r...
Page 23 - Fault Finding; Preliminary Electrical Systems Check
23 Fault Finding Preliminary Electrical Systems Check START Isolate applianceand carry out: A: Earth Continuity check. Has inlet fuse blown? Carry out: C: Polarity check. Electricity supplyshould now besatisfactory. Carry out: D: Resistance to Earth check. Inlet wiringfaulty.Rectify anyfault. Isolat...
Page 24 - A. EARTH CONTINUITY CHECK; contacts clean and tight.
24 A. EARTH CONTINUITY CHECK Appliance must be electrically disconnected - meter set on W (Ohms) x 1 scale and adjust zero if necessary.— Test leads from any appliance earth point to earth pin on plug. Resistance should be less than 0.1 W (Ohm), check all earth wires for continuity and all contacts ...
Page 25 - Ignition System / Gas Ignition
25 Check gas supply atburner Ignition System / Gas Ignition YES Check plug top fuse andreplace if necessary Check polarity and earthcontinuity of supply point Check earth continuityof appliance Ignitor does not spark Check fitting ofburners Check position of theelectrode Check by pass simmeradjusted...
Page 26 - Commissioning; screwdriver and turn the adjustment; Pressure Testing; The pressure testing must becarried out on the burners.; Minimum adjustment screw
26 Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. 1) Turn the gas tap to the MAX position and ignite.2) Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several t...
Page 27 - Conversion from Natural Gas to LPG; Method
27 Conversion from Natural Gas to LPG IMPORTANT The replacement/conversion from natural gas to LPG should only be undertaken bya competent person. It is important to note that this model is designed for use with natural gas but can be converted for use withbutane or propane gas providing the correct...
Page 28 - Standard Guarantee Conditions
28 Standard Guarantee Conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance orany part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, atour option repair or replace the same FREE OF CHARGE fo...
Page 30 - European Guarantee
30 This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move w...
