TRENDNet Network Cable Tester - Manual
TRENDNet Network Cable Tester – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ENGLISH; Install the battery
- Page 3 – Remote Testing; Wall Jack
- Page 5 – Firewire
- Page 6 – LED Status
- Page 11 – TRENDnet
Network Cable Tester
TC-NT2
TC-NT2(V1)/02.26.2013
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ENGLISH Install the battery 1 RJ-11/RJ-45 Cable Test 1. Slide the cover off the TC-NT2 transmitter.2. Connect and insert the battery. 3. Slide the cover back on to the TC-NT2 transmitter. 1. Connect one end of an RJ-11 or RJ-45 cable to the remote port on the TC-NT2 transmitter. Connect the other en...
ENGLISH POWER / TONE OFF / ON TC-NT2 TRANSMITTER AUTO TEST 2 Remote Testing Note: Do NOT use the TC-NT2 for live wire testing. The TC-NT2 is for testing cables only. Do not connect the TC-NT2 to an Ethernet cable that is connected to a switch, router, computer, etc. Doing so will damage the device. ...
ENGLISH TC-NT2 REMOTE TERMINATOR POWER / TONE OFF / ON TC-NT2 TRANSMITTER AUTO TEST 4 Optional Accessory TC-NTUF (Sold Separately) IEEE 1394 (6-pin) / USB Cable1. Connect one TC-NTUF to the remote port on the TC-NT2 transmitter. Connect another TC-NTUF to the loopback port on the TC-NT2 remote termi...
