Traulsen G-Series - Manual

V. e - CLEANING THE INTERIOR:For cleaning both stainless steel and anodized alumi-num interiors, the use of baking soda as described insection “ V. d” is recommended. Use on breaker strips as well as door gaskets. All interior fittings are remov-able without tools to facilitate cleaning. VI. a - ADJ...

-6- LED For ° F LED For ° C 3-Digit (red)LED Display Defrost IconWith LED VII. b - CONTROL PANEL: ° F ° C FREEZER SET ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ VII. c - PARTS ASSEMBLY: HOLDER CLIP*377-60038-00 TRAULSENVERTICAL CONTROLLER**337-60064-00INCLUDES ...

Listed below are the available parameters in the order they appear, using the down arrow key on the controller. You can use either the up or down arrow keys to scroll through the options. Thermostat Set Point High* Defrost Lockout 2 Thermostat Set Point Low Defrost Lockout 3 Temperature Scale Defros...

-11- VII. MICROPROCESSOR CONTROL (continued) VII. k - SETTING THE DATE: The date must be set in order for the data storage memory to correctly log events. Follow the instruc- tions to enter the customer access code on page 7. When the control displays Thermostat Set Point High, press the down arrow ...

° F ° C FREEZER SET This parameter allows a service technician to start a defrost cycle at any time. This parameterwill override any lockout settings. Follow the instructions to enter the customer access code on page 7. When the control displays Thermostat Set High, press the down arrow key until th...

-13- The defrost lockout parameters allow the customer to prevent the unit from going into a defrost cycle for two hours during a set timeframe. Customers can set up to four defrost lockout parameters. They are all programmed the same way. The parameters will be set for the time the lockout is to st...

-14- VII. MICROPROCESSOR CONTROL (continued) VII. o - ADJUSTING THE ROOM TEMPERATURE OFFSET: The room temperature offset parameter allows a service technician or end user the ability to have thedisplay show a temperature that is within three degrees of the actual temperature being read by thecabinet...

VIII. TROUBLE SHOOTING GUIDE FIND YOUR PROBLEM HERE REMEDY 1. Condensing unit fails to start. a. Check if cord & plug has been disconnected. b. Check control temperature setting. 2. Condensing unit operates for a. Are doors closing properly? prolonged periods or continuously. b. Dirty condenser ...

-16- IX. WARRANTY INFORMATION STANDARD DOMESTIC WARRANTY TRAULSEN & CO., INC. warrants new equipment to the original purchaser, when installed within the United States against defective material and workmanship for one (1) year from the date of original installation. Under this warranty, TRAULSE...

Traulsen 4401 Blue Mound Road Fort Worth, TX 76106Phone: (800) 825-8220 Fax-Svce: (817) 740-6757Website: www.traulsen.com HOURS OF OPERATION: Monday thru Friday 7:30 am - 4:30 pm CST Quality Refrigeration