TP-Link TD-W8951NB - Manual

TP-Link TD-W8951NB

TP-Link TD-W8951NB – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
83 Page 83
84 Page 84
85 Page 85
86 Page 86
87 Page 87
88 Page 88
89 Page 89
90 Page 90
91 Page 91
92 Page 92
93 Page 93
94 Page 94
Page: / 94

Table of Contents:

  • Page 2 – COPYRIGHT & TRADEMARKS; Specifications are subject to change without notice.
  • Page 3 – FCC STATEMENT; Reorient or relocate the receiving antenna.; FCC RF Radiation Exposure Statement
  • Page 4 – 당해
  • Page 5 – Safety Information
  • Page 6 – DECLARATION OF CONFORMITY; For the following equipment:; The product carries the CE Mark:; Person responsible for marking this declaration:; Yang Hongliang
  • Page 7 – CONTENTS
  • Page 9 – Package Contents; The following contents should be found in your package:
  • Page 10 – Chapter 1. Introduction; Product Overview; ADSL
  • Page 12 – Chapter 2. Hardware Installation; The Front Panel; Name
  • Page 13 – the Modem Router; please refer to; POWER; : The Power plug is where you will connect the power adapter.; WPS; : This button is for WPS settings. For details, please refer to; RESET; : There are two ways to reset the Router's factory defaults.; Method one
  • Page 14 – Connecting the Modem; Antenna; Installation Environment
  • Page 15 – Connecting the Modem Router; Connect the ADSL Line.; Method two; • LINE: Connect to the wall jack
  • Page 17 – Chapter 3. Quick Installation Guide; Click the; Start; menu on your desktop, right click; My Network Places; Right click; Local Area Connection
  • Page 18 – Select; General
  • Page 21 – Select the; Quick Start; Configure the time for the Router, and then click the; NEXT; Select the connection type to connect to the ISP (We select; NEXT
  • Page 23 – Click; to finish the Quick Start.
  • Page 24 – Chapter 4. Software Configuration; Choose “
  • Page 25 – Status; ” menu, and you will be able to query the logs of the Router.
  • Page 28 – WLAN
  • Page 29 – Interface Setup
  • Page 35 – Yes; After you finish the Internet configuration, please click; SAVE; to make the settings take effect.; Interface Setup
  • Page 38 – If; Use Auto Discovered DNS Server Only; is selected in DNS Relay, this router will accept the; Use User Discovered DNS Server Only; is selected in
  • Page 39 – DHCP Server IP for Relay Agent:; Enter the DHCP server IP Address runs on WAN; Disabled; , the DHCP function will not take effect.; ” menu, and you will see the Wireless screen (shown in
  • Page 41 – Access point Settings:; These are the settings of the access point. You can configure the; Fragmentation Threshold:; This value specifies the maximum size for a packet before
  • Page 47 – Finish; to complete the WPS
  • Page 51 – Advanced Setup; ” menu, and you will see the routing information in the next; ADD ROUTE
  • Page 52 – Destination IP Address:; This parameter specifies the IP network address of the final
  • Page 55 – IP Address Mapping is only available for VCs with Multiple IPs.
  • Page 59 – ”, you can activate the VLAN function in the next screen.; ) Assign VLAN PVID for each Interface; Assign VLAN PVID for each Interface; in Figure 4-33, you can assign the PVID for each
  • Page 60 – ) Define VLAN Group; Define VLAN Group; in Figure 4-33, you can define VLAN groups in the next screen (shown
  • Page 62 – Access Management; Access Management
  • Page 66 – IP/MAC Filter Set Index; and; IP/MAC Filter Rule Index; If you want to make the rule take effect, please select; to active the rule.
  • Page 73 – ”, you can configure the DDNS function in the screen; DDNS; Activate the DDNS function or not.
  • Page 77 – Manually; Maintenance; ”, you can upgrade the firmware of the Router in the screen; Browse; to find the local hard drive and locate the firmware or romfile
  • Page 79 – To restore the Router’s settings:; “New Romfile Location” field.; UPGRADE; button to complete.
  • Page 80 – ”, you can select to restart the device with current settings or; ”, you can view the test results for the connectivity of the
  • Page 81 – Help
  • Page 83 – Appendix A: Specifications
  • Page 84 – Appendix B: Troubleshooting; Note; T2. What can I do if I don’t know or forget my password?
  • Page 85 – Change adapter; Properties
  • Page 86 – Internet; Obtain an IP; Obtain DNS; OK
  • Page 92 – T4. What can I do if I cannot access the Internet?
  • Page 94 – Appendix C: Technical Support; Technical Support
Loading the manual

TD-W8951NB

150Mbps Wireless N ADSL2+ Modem Router
(Annex B)

Rev: 3.0.0
1910010747

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - COPYRIGHT & TRADEMARKS; Specifications are subject to change without notice.

COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form ...

Page 3 - FCC STATEMENT; Reorient or relocate the receiving antenna.; FCC RF Radiation Exposure Statement

FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses a...

Page 4 - 당해

CE Mark Warning This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. This device has been designed to operate with the antennas listed below, and having a maximum gain of 5dBi. Antennas not ...

Other TP-Link Models

All TP-Link Other