Toro 51833T - User Manual

Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any areaof potential danger. Replace any decal that is damaged or missing. decal144-3098 144-3098 decal144-3096 144-3096 decal144-3094 144-3094 1. The battery pack ischarging. 3. Th...

Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Use 1 Allen wrench 1 Unfold the handle. Auxiliary handle assembly 1 2 Edger adjustment tool 1 Install the auxiliary handle. Important: The battery pack is not fully charged when you purchase ...

2 Installing the Auxiliary Handle Parts needed for this procedure: 1 Auxiliary handle assembly 1 Edger adjustment tool Procedure 1. Separate the auxiliary handle from the handle plate by removing the 4 screws (A of Figure 4 ). 2. Line up the auxiliary handle with auxiliary handle plate on the edger ...

Product Overview g429628 Figure 5 1. Battery latch 5. Guard 2. Lockout button 6. Air venting areas 3. Auxiliary handle 7. Blade 4. Run trigger g330065 Figure 6 1. Battery charger Model88610 (included withModel 51833) 2. Battery pack Model 88620(included with Model51833) Specifications Model 51833 Bl...

Operation Starting the Edger 1. Align the cavity in the battery pack with thetongue on the handle housing ( Figure 7 ). 2. Push the battery pack into the handle until thebattery locks into the latch ( Figure 7 ). g333238 Figure 7 1. Battery latch 3. To start the edger, pull back on the lockoutbutton...

Adjusting the Depth of Cut 1. Remove the battery from the edger. 2. Loosen the wing nut on the wheel and move itup or down in the track to increase or decreasethe depth ( Figure 10 ). g333293 Figure 10 3. Adjust the depth so that the blade barely touchesthe ground when the machine is held in a norma...

Charging the Battery Pack Important: The battery pack is not fully charged when you purchase it. Before using the tool forthe first time, place the battery pack in the chargerand charge it until the LED display indicates thebattery pack is fully charged. Read all safetyprecautions. Important: Charge...

Operating Tips • Hold the edger with your right hand on the rearhandle and your left hand on the front handle. • Keep a firm grip with both hands while in operation. • The edger should be held at a comfortable positionwith the rear handle at about hip height. • The edger will edge along sidewalks, d...

Maintenance After each use of the edger, complete the following: 1. Remove the battery from the edger. 2. Wipe the edger clean with a damp cloth. Do nothose the edger down or submerge it in water. 3. Wipe or scrape clean the cutting head area anytime there is an accumulation of debris. 4. Check and ...

6. Tighten the wing nut to secure the wheel. Replacing the Skid Plate If the skid plate becomes worn or damaged, replaceit; contact your authorized Toro distributor. 1. Ensure that the battery is removed from themachine. 2. Remove the 2 screws securing the skid plate tothe edger ( Figure 12 ). g3446...

Troubleshooting Perform only the steps described in these instructions. All further inspection, maintenance, and repair workmust be performed by an authorized service center or a similarly qualified specialist if you cannot solve theproblem yourself. Always remove the battery from the tool when trou...

California Proposition 65 Warning Information What is this warning? You may see a product for sale that has a warning label like the following: WARNING: Cancer and Reproductive Harm—www.p65Warnings.ca.gov. What is Prop 65? Prop 65 applies to any company operating in California, selling products in C...