Toro 38583 - Manual
Toro 38583 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Shut the engine off !; Maintenance and Storage; Operator’s Manual; Toro Snowthrower Safety; and wait for all moving parts to stop.
- Page 4 – Safety and Instructional Decals
- Page 5 – Setup; Loose Parts; Unfolding the Handle; Procedure; Loosen the lower handle knobs, pull out the handle; Insert the end of the “U”-shaped handle lock into; Ensure that you do not pinch or
- Page 6 – For easier installation, use a small ratchet wrench; Do not overtighten the screws; Adjusting the Control Cable; Refer to Adjusting the Control Cable in Maintenance.; Product Overview; Operation; Determine the left and right sides of the machine
- Page 7 – Mixing Gasoline and Oil; To prevent engine damage, do not use; Filling the Fuel Tank; Do not use E85 or E20 fuel. Alternative; Starting the Engine
- Page 8 – Firmly push in the primer 2 times with your thumb,; Do not use the primer or the; Connect an extension cord to a power source and; Run the electric starter no more; While the engine is running, move the choke lever to
- Page 9 – Engaging the Rotor Blades; Disengaging the Rotor Blades
- Page 11 – Operating Tips; Maintenance
- Page 12 – Checking the Control Cable; The control cable must contain some; Adjusting the Control Cable
- Page 13 – NGK BPMR4A
- Page 14 – Replacing the Drive Belt
- Page 16 – Hold the discharge chute in the straight-ahead; Pull the upper cable casing forward until you remove; Do not over-tension the cables. If the cables
- Page 17 – Storage; Storing the Snowthrower; Do not use the chute handle to lift the
- Page 20 – The Toro 5-Year GTS Starting Guarantee and
Form No. 3358-430 Rev B
Power Clear™ Snowthrower
Model No. 38583—Serial No. 280000001 and Up
Model No. 38584—Serial No. 280000001 and Up
Operator's Manual
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Figure 1
1.
Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
Figure 2
1.
Safety alert symbol
This manual uses 2 words to highlight information.
Important
calls attention to special mechanical
information and
Note
emphasizes general information
worthy of special attention.
Warning
CALIFORNIA
Proposition 65 Warning
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
This spark ignition system complies with Canadian
ICES-002.
The enclosed
Engine Owner’s Manual
is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission systems,
maintenance, and warranty. Replacements may be
ordered through the engine manufacturer.
Safety
This snowthrower meets or exceeds the B71.3
specifications of the American National Standards
Institute in effect at the time of production.
Read and understand the contents of this manual
before you start the engine.
This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
Improperly using or maintaining this snowthrower
could result in injury or death. To reduce this
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
• Look behind and use care when backing up with thesnow thrower. • Disengage power to the rotor blades when snowthrower is transported or not in use. • Never operate the snow thrower without goodvisibility or light. Always be sure of your footing, andkeep a firm hold on the handles. Walk; never run....
Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 94-2577 1. To engage the rotor blades, hold the control bar againstthe handle. 2. To disengage the rotor blades, release the control bar. 108-4939 1. Cutting d...
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. Use 1. No parts required – Unfold the handle. Screws 3 2. Chute assembly 1 Install the discharge chute. 1. Unfolding the Handle Procedure 1. Loosen the lower handle knobs, pull out the handle...
