Toro 20200 - Manual
Toro 20200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Safety; General Operation; Slope Operation
- Page 3 – Children; Never; Service; Safe Handling of Gasoline
- Page 4 – Safety and Instructional Decals
- Page 5 – Setup; Remove and discard the protective; Assembling the Handle; No Parts Required
- Page 6 – Filling the Engine with Oil; Parts needed for this procedure:; Procedure; This machine; slowly
- Page 7 – Charging the Battery; Product Overview
- Page 8 – Operation; Before Starting; DANGER; Do not; Filling the Fuel Tank
- Page 9 – Checking the Engine Oil Level; Adjusting the Cutting Height; WARNING
- Page 10 – Adjusting the Handle Height; Starting the Engine; Standard Model; Do not attempt to start the engine
- Page 11 – Engaging the Blade
- Page 12 – Disengaging the Blade; When you release the blade-control; Using the Grass Bag
- Page 13 – Recycling the Clippings; Bagging the Clippings
- Page 14 – Removing the Grass Bag; Side-discharging the Clippings; Ensure that the rear-discharge plug is; Removing the Side-discharge Chute
- Page 15 – Operating Tips; General Mowing Tips
- Page 16 – Maintenance; Refer to the; Preparing for Maintenance; Before tipping the mower to change
- Page 17 – Servicing the Air Filter; Keep dirt away from the air opening.; Changing the Engine Oil
- Page 18 – Wash hands after handling
- Page 19 – Replacing the Fuse; Replacing the Battery; Removing the Old Battery; Installing the New Battery
- Page 21 – Do not overtighten the adjusting; Servicing the Cutting Blades; You will need a torque wrench to install; Replace a worn or damaged blade.; Preparing to Service the Cutting Blades; Disconnect the wire from the spark plug.; Inspecting the Blades
- Page 22 – Checking for Bent Blades
- Page 23 – Installing the Blades; Position the curved ends of the
- Page 25 – Storage; General Information; Do not store gasoline over long periods of time.; Preparing the Engine
Form No. 3369-191 Rev A
TimeMaster™ 30in Lawn Mower
Model No. 20199—Serial No. 31200001 and Up
Model No. 20200—Serial No. 31200001 and Up
Operator's Manual
Introduction
This rotary-blade, walk-behind lawn mower is
intended to be used by residential homeowners.
It is designed primarily for cutting grass on
well-maintained lawns on residential properties. It
is not designed for cutting brush or for agricultural
uses.
Read this information carefully to learn how to operate
and maintain your machine properly and to avoid
injury and equipment damage. You are responsible for
operating the machine properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a dealer,
or to register your product.
Whenever you need service, genuine Toro parts,
or additional information, contact an Authorized
Service Dealer or Toro Customer Service and have
the model and serial numbers of your machine ready.
Figure 1 identifies the location of the model and serial
numbers on the product. Write the numbers in the
space provided.
1
G017280
Figure 1
1.
Model and serial number plate
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 2),
which signals a hazard that may cause serious injury
or death if you do not follow the recommended
precautions.
Figure 2
1.
Safety alert symbol
This manual uses 2 words to highlight information.
Important
calls attention to special mechanical
information and
Note
emphasizes general information
worthy of special attention.
WARNING
CALIFORNIA
Proposition 65 Warning
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Important:
This engine is not equipped with a
spark arrester muffler. It is a violation of California
Public Resource Code Section 4442 to use or operate
the engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
This spark ignition system complies with Canadian
ICES-002.
The enclosed
Engine Owner's Manual
is supplied
for information regarding the US Environmental
Protection Agency (EPA) and the California
Emission Control Regulation of emission systems,
maintenance, and warranty. Replacements may be
ordered through the engine manufacturer.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
engine manufacturer in accordance with SAE J1940.As configured to meet safety, emission, and operatingrequirements, the actual engine horsepower on this classof lawn mower will be significantly lower. Do not tamper with the engine controls or alter thegovernor speed; doing so may create an unsafe co...
• Do not mow on wet grass or excessively steep slopes.Poor footing could cause a slip-and-fall accident. • Do not mow near drop-offs, ditches, orembankments. You could lose your footing orbalance. Children Tragic accidents can occur if the operator is not alert tothe presence of children. Children a...
Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer's Mark 1. Indicates that the blade is identified as a part from theoriginal machine manufacturer. 94-8072 108-8117 108-9751 Electric-start model o...