Page 2 - Taylor Company
Complete this page for quick reference when service is required: Taylor Distributor: Address: Phone: Service: Parts: Date of Installation: Information found on data plate: Model Number: Serial Number: Electrical Specs: Voltage Cycle Phase Maximum Fuse Size: Amps Minimum Wire Ampacity: Amps Part Numb...
Page 3 - Table of Contents
Models 150, 152, 162, 168 Table of Contents Table of Contents Section 1 To the Installer 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installer Safety 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 4 - Table of Contents - Page 2
Table of Contents Models 150, 152, 162, 168 Table of Contents - Page 2 Closing Procedure 25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Draining Product From the Freezing Cylinder 25 . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....
Page 5 - To the Installer; Section 1; Installer Safety; Note: All repairs must be performed by an; Site Preparation; NOT
1 Models 150, 152, 162, 168 To the Installer 131122 Section 1 To the Installer The following information has been included in the manual as safety and regulatory guidelines. For complete installation instructions, please see the Installation Checklist. Installer Safety In all areas of the world, equ...
Page 6 - Electrical Connections For
2 Models 150, 152, 162, 168 To the Installer 101122 Air Cooled Units The models 150 and 152 require a minimum of 6” (152 mm) of clearance around both sides. Install the skirt provided on the right side of the unit and place the back of the unit against a wall to prevent recirculation of warm air. Th...
Page 7 - Beater Rotation; Note: The following procedures should be; Refrigerant
3 Models 150, 152, 162, 168 To the Installer 130809 S Stationary appliances which are not equipped with a power cord and a plug or another device to disconnect the appliance from the power source must have an all-pole disconnecting device with a contact gap of at least 3 mm installed in the external...
Page 8 - Compressor Warranty Disclaimer
4 Models 150, 152, 162, 168 To the Operator 131122 Section 2 To the Operator The freezer you have purchased has been carefully engineered and manufactured to give you dependable operation. The Taylor Company models covered in this manual consist of the following: 150, 152, 162 and 168. These units, ...
Page 11 - Operator Parts Identification; Section 4
7 Models 150, 152, 162, 168 Operator Parts Identification Section 4 Operator Parts Identification Model 150 Figure 1 Item Description Part No. 1 Cover A.- Hopper X48690 2 Tube- Feed- .166 Hole 035819 3 Float A.- Mix Level X39690 4 Panel- Back Top 050429 5 Panel- Upper Side Left 030783- SS 6 Pan- Dri...
Page 19 - Important: To the Operator; Section 5; Symbol Definitions
15 Models 150, 152, 162, 168 Important: To the Operator Section 5 Important: To the Operator Figure 9 Item Description 1 Reset Button 2 Power Switch 3 Temperature Control 4 Mix Refrigeration Switch 5 Indicator Lights - “Mix Low” Symbol Definitions To better communicate in the International arena, th...
Page 21 - Cylinder Temperature Retention; To operate the “STANDBY” mode of operation:
17 Models 150, 152, 162, 168 Important: To the Operator Cylinder Temperature Retention (CTR) To maintain a good quality product during long “No Sale” periods, it will be necessary to warm the product in the freezing cylinder to approximately 35 _ to 40 _ F (1.7 _ to 4.4 _ C). This will prevent overb...
Page 22 - Operating Procedures; Section 6
18 Models 150, 152, 162, 168 Operating Procedures 120501 Section 6 Operating Procedures The Model 150 has been selected to illustrate the pictured step- by- step operating procedures. All models in this manual are similar. They each have a 1.5 quart (1.4 liter) capacity freezing cylinder. The mix fl...
Page 23 - Assembly; Do not
19 Models 150, 152, 162, 168 Operating Procedures 120501 Assembly Note: When lubricating parts, use an approved food grade lubricant (example: Taylor Lube). Step 1 Lubricate the groove on the beater drive shaft. With the opening of the cup seal facing away from the hex end, slide the seal into the g...
Page 26 - Sanitizing
22 Models 150, 152, 162, 168 Operating Procedures Note: Models 162/168 have three draw handles. Slide the tip of the draw handle into the slot of the draw valve, starting from the right. Slide the short pivot pin through the far right draw handle. Slide the long pivot pin through the far left and mi...
Page 28 - Priming; fresh
24 Models 150, 152, 162, 168 Operating Procedures Priming Prime the machine as close as possible to the time of first product draw. Step 1 With a pail beneath the door spout, raise the draw valve. Fill the mix hopper with fresh mix. (Maximum hopper capacity is 8 quarts [7.6 liters].) Allow the mix t...
Page 29 - Rinsing
25 Models 150, 152, 162, 168 Operating Procedures 140721 Step 6 Slide the rear drip pan into the hole in the side panel. Figure 40 Closing Procedure To disassemble the Models 150/152/162/168, the following items will be needed: S Two cleaning pails S Sanitized stainless steel rerun can with lid S Ne...
Page 30 - Disassembly; Make sure the power switch is in the OFF; Brush Cleaning
26 Models 150, 152, 162, 168 Operating Procedures 120529 Step 5 Place an empty pail beneath the door spout and raise the draw valve. Draw off all the cleaning solution. When the solution stops flowing from the door spout, lower the draw valve and place the power switch in the “OFF” position. Repeat ...
Page 31 - During Cleaning and Sanitizing; Troubleshooting Bacterial Count
27 Models 150, 152, 162, 168 Important: Operator Checklist Section 7 Important: Operator Checklist During Cleaning and Sanitizing ALWAYS FOLLOW LOCAL HEALTH CODES. Cleaning and sanitizing schedules are governed by federal, state, or local regulatory agencies, and must be followed accordingly. If the...
Page 32 - Winter Storage
28 Models 150, 152, 162, 168 Important: Operator Checklist j 5. If your machine is air cooled, check the condenser for an accumulation of dirt and lint. A dirty condenser will reduce the efficiency and capacity of the machine. Condensers should be cleaned monthly with a soft brush. Never use screwdr...
Page 33 - Troubleshooting Guide; Section 8; PROBLEM
29 Models 150, 152, 162, 168 Troubleshooting Guide Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAGE REF. 1. No product being dispensed. a. The power switch is in the “OFF” position. a. Place the power switch in the “AUTO” position. 24 b. The mix level is inadequate in the mix hoppe...
Page 35 - separate
31 Models 150, 152, 162, 168 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAGE REF. 9. The unit goes out on overload excessively. a. There are too many appliances plugged into the circuit. a. A separate 20 amp. circuit is needed for the freezer to operate properly. - - - b. An extension cord ...
Page 36 - Parts Replacement Schedule; Section 9
32 Models 150, 152, 162, 168 Parts Replacement Schedule 120501 Section 9 Parts Replacement Schedule PART DESCRIPTION EVERY 3 MONTHS EVERY 6 MONTHS ANNUALLY QTY. 150/152 162/168 Beater Drive Shaft Cup Seal X 1 2 Freezer Door O- Ring X 1 2 Freezer Door Front Bearing X 1 2 Freezer Door Guide Bearing X ...
Page 37 - Limited Warranty on Equipment
33 Models 150, 152, 162, 168 Limited Warranty on Equipment 131122 Section 10 Limited Warranty on Equipment TAYLOR COMPANY LIMITED WARRANTY ON FREEZERS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor-branded fre...
Page 39 - Limited Warranty on Parts; TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS; LIMITED WARRANTY CONDITIONS
35 Models 150, 152, 162, 168 Limited Warranty on Parts 131122 Section 11 Limited Warranty on Parts TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor genuine...
Page 41 - must
37 Models 150, 152, 162, 168 Limited Warranty on Parts LIMITATION OF WARRANTY THIS LIMITED WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER WARRANTIES, CONDITIONS AND/OR REMEDIES UNDER THE LAW, INCLUDING ANY IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TH...
Page 42 - Parts List
Section 12 Parts List + Available Separately 38 Parts List Models 150, 152, 162, 168 120501 DE S CRI P T IO N P ART NUM BE R 150 QTY . 152 QTY . 162 QTY . 168 QTY . W ARR. CL AS S RE M ARKS PART S UP DA T E BEARI N G- FRONT 023262 1 1 2 2 000 BEARI N G- GUI D E 014496 1 1 2 2 000 BEARI N G- REAR SHE...
