Sun Microsystems FC-100 - Manual

Table of Contents:

• Page 3 – Regulatory Compliance Statements; FCC Class A Notice
• Page 5 – Safety Agency Compliance Statements
• Page 7 – Gehäuseabdeckung; Conformité aux normes de sécurité; Mesures de sécurité; Symboles
• Page 8 – Normativas de seguridad
• Page 10 – Aviso de cumplimiento con requisitos de láser; GOST-R Certification Mark
• Page 11 – Declaration of Conformity; EMC
• Page 13 – Contents; Product Description
• Page 14 – Installing a GBIC
• Page 15 – Preface; Using UNIX Commands; This document does not contain information on basic UNIX
• Page 16 – su
• Page 17 – Related Documentation; The; web site enables you to access Sun technical documentation; Sun Welcomes Your Comments
• Page 19 – Sun StorEdge FC-100 Hub; The following conditions will cause the bypass of a port:
• Page 21 – GBIC
• Page 23 – Installation; This chapter describes how to install the hub in a cabinet.; Inspecting the Hub; Inspect the hub for evidence of damage.; Rackmount Placement
• Page 24 – Installing the Hub; Tools You Will Need; Extend the antitilt bar; Installing the Mounting Tray in the Cabinet
• Page 25 – Caution –; Use only SAE 10-32 screws to secure the tray to the cabinet mounting; screws each for the left and right side.
• Page 26 – Installing the Hub on the Mounting Tray; The first hub goes in position A the second goes in position B.; Note –; The front and rear mounting plastics are interchangeable.
• Page 27 – Installing GBICs and Fiber Optic Cables; Choose the hub port into which you will install the GBIC.; and; Forcing a GBIC into a port can damage the GBIC and/or port. Use
• Page 28 – Connect the fiber optic cable to the GBIC.; Route the fiber optic cable to an initiator or target.; Connect the fiber optic cable to a GBIC in the initiator or target.; Refer to the documentation that came with the device.; Routing the Power Cord
• Page 29 – left side of the cabinet.; Verifying the Configuration; Make sure that the Device Active LEDs are lit for active hub ports.; The Bypass LEDs for active ports should be off.
• Page 30 – Reassembling the Cabinet; Replace or close the top front panel; If the Device Active LED for a GBIC is flashing, replace the GBIC.
• Page 31 – Service
• Page 34 – Removing a GBIC; Disconnect the fiber optic cable from the GBIC (
• Page 36 – Removing a Hub; Disconnect and remove any installed fiber optic cables or GBICs (; Pull the hub back and then lift it out of the mounting slots.
• Page 37 – Specifications; Physical