Summit Appliance HP-1 - Manual

Page 2 - TABLE OF CONTENTS

TABLE OF CONTENTS Introduction Components Safety Instructions Environmental Conditions Assembly & Disassembly Adjustments for Seating Comfort Operation Batteries and Charger Maintenance and Repair Specifications Limited Warranty 1 2 3 6 7 11 12 16 18 21 22

Page 3 - INTRODUCTION

Thank you for choosing a Summit Power mobility product. We hope that it will provide many years of mobility for you. This is a general manual for our power wheelchairs, HP-1, HP-1L, and HP-1S. The information in this manual applies to all these models. HP-1 is a power wheelchair with seat width of 1...

Page 4 - COMPONENTS

COMPONENTS Your power wheelchair is shipped partially disassembled to protect it during shipping. After unpacking, please check whether you have received the following main components as our standard specification (Fig. 1). 1. Main frame with motor and gearbox 8. Battery supporting bar 2. Flip-back ...

Page 5 - SAFETY INSTRUCTIONS; Operation of Chair; Ramps and Curbs

SAFETY INSTRUCTIONS Page 3 Operation of Chair 1. Always ensure that the power is switched off when getting in or out of the wheelchair. This will eliminate the possibility of accidentally activating the joystick and causing injury to yourself or others. 2. Always check that the drive wheels are enga...

Page 6 - General

SAFETY INSTRUCTIONS Page 4 B Position chair so that the distance between your power chair and the object to which you are transferring is close enough for a safe transfer. B Turn the power off. B Ensure that your power chair is not in freewheel mode. B Flip up or remove armrests. B Flip up footplate...

Page 9 - ASSEMBLY & DISASSEMBLY; ASSEMBLY

ASSEMBLY & DISASSEMBLY ASSEMBLY A. Opening the wheelchair Standing at one side of the wheelchair, tilt it to one side, and push down firmly on the seat rails. The seat should be locked into the receivers on the wheelchair side frame when the chair is fully opened. B. Installing the batteries (no...

Page 11 - DISASSEMBLY

ASSEMBLY & DISASSEMBLY DISASSEMBLY A. Battery removal For transportation B Unplug the battery connector from the controller connector underneath the seat near the crossbar. Refer to Assembly, Section D, Connecting the main cables on Page 8. B Unscrew the knobs and remove the battery bar at the r...

Page 13 - ADJUSTMENTS FOR SEATING COMFORT

ADJUSTMENTS FOR SEATING COMFORT To maximize seating comfort, your power wheelchair lets you adjust: B Armrest height. B Controller position. B Flip-back and detachable armrest. B Footrest height. A. Armrest height (Adjustable up to 4” in 1” increments) To adjust the armrest height, pull and hold the...

Page 14 - OPERATION

OPERATION The power wheelchair is simple to operate. However, we recommend that you read carefully the following instructions to become familiarized with your new vehicle. A Word of Caution: Before you turn the power on, always be aware of the environment that surrounds you to select your desired sp...

Page 23 - SPECIFICATIONS

SPECIFICATIONS HP1 HP1L HP1S HP1 HP1L HP1S Length: 43.5 43.5 43.5 MAXIMUM SPEED 5.0 mph DIMENSION Width close: 17.5 20.0 14.5 RANGE Up to 20.0 miles (INCHES) Width open: 25.5 27.5 23.5 TURNING RADIUS 33.0” Height: 38.0 38.0 38.0 GRADIENT 10 - 12 degrees Width: 18.0 20.0 16.0 GROUND CLEARANCE SEAT De...

Page 24 - LIMITED WARRANTY

Five-Year Limited Warranty: Power chair frame We will repair the frame with new or refurbished parts, free of charge, in the USA, in the event of defective materials or workmanship. One-Year Limited Warranty: Electronic controller, drive train components We will repair these products with new or ref...

Page 25 - authorized SUMMIT DME dealer