Page 2 - We Care for the Environment
*Before Putting Into UsE* Before connecting the appliance to the power supply, leave it standing for about 2 hours, this will reduce the possibility of malfunctions in the cooling system due to transport handling. Clean the appliance thoroughly; especially in the interior (See Cleaning and Maintenan...
Page 3 - IMPORTANT; Disposing of the Worn Out Appliance
IMPORTANT If you bought this appliance to replace an old one equipped with a lock that cannot be opened from inside (lock, bolt), make sure that the lock is broken. This will make it impossible for children to lock themselves inside the appliance and suffocate. The appliance must be correctly connec...
Page 4 - PLACING AND INSTALLATION; Connection to Power Supply; “DO NOT USE AN EXTENSION CORD.”; Operation Control
PLACING AND INSTALLATION It is important to make sure the appliance is leveled evenly to prevent falling. Two spacers attached to the appliance must be fitted onto the upper edge of the condenser, thus preventing the appliance from being installed too close to the wall. Spacers are manufactured for ...
Page 5 - Storing Fresh Foods; Food should not touch the rear wall of the freezer.
Storing Fresh Foods Food to be stored in the freezer should be properly packed as to prevent mixing various moisture degrees and odors (in polyethylene bags or sheet, aluminum foil, wax paper, covered containers or bottles). Never store any inflammable, volatile or explosive substances. Food should ...
Page 6 - Cleaning the Appliance; Switch Off the Appliance When Not in Use
Self-defrosting There is no need to defrost the freezer, because this appliance is self-defrosting. Cleaning the Appliance Disconnect the power supply before cleaning the appliance. Do not use coarse or aggressive cleaning agents as you can damage the surface. Clean the exterior with water and a mil...
Page 7 - Trouble-Shooting Guide
Trouble-Shooting Guide During the service of your appliance, you can come across some trouble that in most cases result from improper handling of the appliance that can easily be eliminated. Appliance Fails to Operate After Connecting to the Power Supply : Check the supply in the outlet socket and m...
Page 8 - Door swing reversal
Door swing reversal ( Stainless steel models with towel bar handles do not have reversible doors.) If you find the direction of opening the door on your appliance inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory 1. Remove the top hinge cover and h...
Page 9 - Noise; Before Calling for Service; Specifications are Subject to Change Without
Noise During the operation of the compressor, a liquid noise is heard and when the compressor is not operating a refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance. After starting the appliance, the operation of the compressor an...