State Water Heaters 198067-000 - Manual
State Water Heaters 198067-000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – LOCAL CODES; WARNING; WARNING; LOCATING THE GEOTHERMAL STORAGE TANK; CAUTION; INSTALLATION
- Page 4 – WATER PIPING; FILLING THE GEOTHERMAL STORAGE
- Page 5 – THERMOSTAT
- Page 6 – TEMPERATURE ADJUSTMENT; TEMPERATURE REGULATION; TEMPERATURE SETTINGS; OPERATION
- Page 7 – MAINTENANCE; DRAINING; ELEMENT; ANODE
- Page 8 – REPAIR PARTS; REPAIR PARTS SCHEDULE; ORDERING REPAIR PARTS
1
1
The storage tank is sold as a component part. It has been
factory equipped with a booster element, and thermostat with
high limit.
The tank is designed to store potable water within the limits
listed on the rating plate and to supply domestic hot water up to
the element’s heating capability.
This manual contains basic instructions for the installation,
operation and maintenance of the storage tank only. Read it
carefully before using the tank, then keep it handy for quick
reference.
If the tank leaks or the element fails to operate, all technical and
warranty questions should be directed to the local dealer from
whom the tank was purchased. If you are unsuccessful, please
write to the company listed on the warranty sheet which came
with the tank.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. Refer to
this manual. For assistance or additional information consult
a qualified installer, service agency or the local utility.
RATING PLATE
A rating plate identifying the manufacturer of the tank will be
found above the drain valve. When referring to the tank,
always have the information listed on the rating plate readily
available.
Fill in that information here:
MODEL NO. _______________________________________
SERIAL NO. _______________________________________
INSTALLATION DATE: ________________________________
THE MANUFACTURER OF THIS TANK WILL NOT BE LIABLE FOR ANY DAMAGE DUE TO FAILURE TO FOLLOW THESE
INSTALLATION AND OPERATING INSTRUCTIONS.
PRINTED 0108
198067-000
GEOTHERMAL STORAGE TANKS
INSTALLATION • OPERATION • MAINTENANCE
INSULATING JACKETS:
When installing an external insulation jacket on the tank:
•
DO NOT cover the temperature-pressure relief valve.
•
DO NOT cover the instruction manual. Keep it on the
side of the water heater or nearby for future reference.
•
DO obtain new warning and instruction labels from
the manufacturer for placement on the blanket directly
over the existing labels.
Failure to follow these instructions can result in serious
personal injury or death.
Month
Day
Year
Instruction Manual
WARNING
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 3 WARNING Never operate the electrical heating element without beingcertain the tank is completely filled with water. If any air is left inthe top of the tank, the heating element will burn out. LOCAL CODES The installation of the tank must be in accordance with theseinstructions and all applicabl...
4 CAUTION This tank, as all tanks, will eventually leak. Do not install withoutadequate drainage provisions where water flow will causedamage. Note: normal condensation from a tank may appearto be a leaking tank. WATER PIPING This tank is design certified to be used with a potable watersystem. When ...
5 5 WARNING TANKS EQUIPPED FOR ONE TYPE VOLTAGE ONLY. This tank isequipped for one type of voltage only. Check the rating platenear the bottom access panel for the correct voltage. DO NOTUSE THIS TANK WITH ANY VOLTAGE OTHER THAN THE ONESHOWN ON THE MODEL RATING PLATE. Failure to use thecorrect volta...
