Star Micronics PW2000-24 - Manual

Star Micronics PW2000-24

Star Micronics PW2000-24 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – Connector
  • Page 3 – INSTALLING THE SPOOL
  • Page 4 – TRICE
Loading the manual

PW2000-24

USER’S MANUAL

MODE D’EMPLOI

BEDIENUNGSANLEITUNG

MANUALE DI ISTRUZIONI

80871080

After unpacking the unit, check that all the necessary accessories are included
in the package.

Après avoir déballé l’appareil, vérifiez si tous les accessoires nécessaires se trouvent
dans la boîte.

Öffnen Sie den Kartoninhalt, und vergewissern Sie sich, daß alle unten abge-
bildeten Teile vorhanden sind.

Dopo aver disimballato l’unità, controllare che tutti gli accessori necessari siano inclusi
nella confezione.

1. Turn off power to the printer.

2. Lift the cover up approx. 3 cm. Hold the cover tilted at this angle, then pull it

toward you to remove it.

1. Mettez l’imprimante hors tension.

2. Soulevez le capot d’environ 3 cm. Tout en tenant le couvercle incliné à cet angle,

tirez-le vers vous pour l’enlever.

1. Stellen Sie den Netzschalter am Drucker in Aus-Stellung.

2. Zum Abnehmen der Frontabdeckung heben Sie diese ca. 3cm an, und zie-

hen sie dann nach vorne.

1. Spegnere la stampante.

2. Sollevare il coperchio di 3 cm circa. Tenere il coperchio inclinato a questa angola-

zione e tirarlo verso di sè per rimuoverlo.

3. Remove the 4 screws.

4. Remove the upper cover.

3. Enlevez les 4 vis.

4. Enlevez le couvercle supérieur.

3. Die 4 Schrauben entfernen.

4. Die obere Abdeckung entfernen.

3. Rimuovere le 4 viti.

4. Rimuovere il coperchio superiore.

1. UNPACKING

1. DÉBALLAGE

1. ÜBERPRÜFEN

1. DISIMBALLAGGIO

Spool

Bobine

Spule

Spola

Rewinder

Rembobineuse

Rückspulvorrichtung

Riavvolgitore

Self-tapping screws (2)

Vis autotaraudeuses (2)

Schneidschrauben (2)

Viti autofilettanti (2)

1

2. INSTALLING THE REWINDER

2. RÉGLAGE DE LA REMBOBINEUSE

2. EINSTELLEN DLER RÜCKSPULVORRICHTUNG

2. INSTALLAZIONE DEL RIAVVOLGITORE

Cover

Capot

Frontabdeckung

Coperchio

Power off

Hors tension

Netzschalter aus

Spegnere

2

3

PW2000-24̲A4.fm  1 ページ  1999年10月21日 木曜日 午後5時20分

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Connector

5. Set the rewinder on the printer so that the bosses of the printer enter the holes of the rewinder. 6. Tighten the two screws. 5. Installez la rembobineuse sur l’imprimante. Mettez-la en place de telle façon que les bosses de l’imprimante pénètrent dans les trous de la rembobineuse. 6. Resserrez l...

Page 3 - INSTALLING THE SPOOL

11. Use the procedure under “Loading the Ribbon Cartridge and Paper” on page 15 of the separate “User’s Manual” to install a roll of 2-ply paper. 12. Feed approximately 20 cm of roll paper from the paper exit by pressing the [FEED] button. 11. Utilisez la procédure décrite dans “Chargement du ruban ...

Page 4 - TRICE

16. Press the [FEED] button to wind the paper a round the take-up spool. Hold down the [FEED] button until there is no slack in the paper. 16. Appuyez sur la touche [FEED] pour rembobiner le papier sur la bobine réceptrice. Maintenez la touche [FEED] enfoncée jusqu’à ce le papier soit tendu. 16. Die...

Other Star Micronics Models

All Star Micronics Other