Stanton RM-402 - Manual - manualsarea.com

Page 2 - Please read carefully before use of this product

Please read carefully before use of this product failure to follow the instructions printed below may void warranty • Follow all security advice printed on your mixer • When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself! • Avoid placing your mixer ...

Page 3 - Welcome

Congratulations on your choice of the Stanton RM.402 ProfessionalDJ Mixer. You now own one of the most flexible DJ mixers everdesigned. The rackmountable RM.402 offers up to three Microphoneinputs, three Phono inputs and nine Line inputs—making it one of themost powerful DJ mixers around. And with S...

Page 4 - Making Connections; Channel

Making Connections Are you ready to get on the 1’s and 2’s? Let’s make sure you’ve madeall the right connections… Mic 2 Here you can connect a microphone using a 1/4-inch cable. If youhave an XLR-type cable, use the Mic 1 input located on the frontpanel. Channel This channel offers two Line inputs f...

Page 6 - Description of Functions

Description of Functions At this point, you’re pretty much ready to start mixing. So if you’re aknow-it-all, or you’re just one of those people who like to learn by trial-and-error, you are free to throw down. But if you wanna go for the goldand get your pilot’s license, take a moment and learn what...

Page 7 - Crossfader Source selectors:

Description of Functions 6. Headphone outputs: Connect up to two pairs of stereo headphones using 1/4-inch and 1/8-inch jacks. 7. Cue Pan slider: This adjusts the relative headphone balance between the Cue mix (PFL) and Master output (PGM). 8. Fader Start switch: Lets you automatically start a CD pl...

Page 8 - Input Selector switches:; SUPERIOR SOUND TECHNOLOGY

16. Input Selector switches: Use these to choose between the Phono, Line and Mic inputs. 17. Talkover switch: Switch this to the “ON” position to enable Microphones 1 and 2. When moved to the “Talkover” position, the music is lowered by a preset amount when the mic is in use. 18. Mic Level knobs: Us...

Page 9 - Application Example

This is a typical setup you’ll find in many nightclubs: 2 turntables, 2 CDplayers, plus a microphone for the DJ. Here’s how you would set upyour equipment with the RM.402: 1. Be sure all equipment is powered “OFF” and all of the RM.402’s Channel faders and Level knobs are at minimum volume. 2. Conne...

Page 10 - Technical Specifications

Technical Specifications Frequency Response THD+N (Line) Signal to Noise Ratio (ref: max level) Noise Crosstalk (Line to Line, Phono to Line, Line to Phono) Fader Kill Microphone EQ Graphic EQ (7 band stereo) Line Inputs Phono Inputs Phono / CD Mic Inputs Master Outputs Zone Output Booth Output Reco...

Page 11 - Troubleshooting; Possible Cause/ Solution

Troubleshooting Problem / Symptom Possible Cause/ Solution No Sound Is the power on? Check the power switch.Makesure the channels are assigned properly to the crossfaders. Make sure INPUT GAIN, is turnedup and output level control is turned up.Depending on the input, check the rear panelselector swi...

Stanton RM-402 - Manual

Table of Contents:

Summary

Other Stanton Models