Smeg SWC120X-1 - User Manual

Page 2 - IMPORTANT SAFEGUARDS

IMPORTANT SAFEGUARDS Read all instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this instruction manual. 2. This Beverage Cooler must be properly ...

Page 3 - SAVE THESE INSTRUCTIONS!; Table of Contents

11.If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard . WARNING : Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction WARNING : Do not use mechanic...

Page 6 - Electrical Connection; Safety Instructions:

5. In order for the appliance to release heat quickly and to have sufficient ventilation, there should be enough space around the appliance. The appliance should be placed in a position with a minimum space of 100mm on all sides. 6. The appliance must be positioned so that the plug is accessible. El...

Page 7 - Operating Your Wine and Beverage Cooler; Two-Compartment Design

6. If a leakage occurs from the gas pipes, you must exhaust the inflammable gases around the appliance. Never pull out the power plug from the socket or switch off the thermostat, as can be a possibility of an explosive ignition caused by electric sparks. 7. Never touch the inner wall of the applian...

Page 8 - OPERATING INSTRUCTIONS; Turning the Unit On; Compressor Run Indicator

OPERATING INSTRUCTIONS Turning the Unit On The unit turns on automatically when it is plugged in. If you want to use the Automatic Temperature (default) setting, do nothing further. The unit will automatically set the temperature in the wine compartment at 13 degrees Celsius and the beverage compart...

Page 9 - Timed defrosting

Your unit has been designed to ”remember” the last run mode to which it was set. If you have a power outage or any other power cut off, the unit will automatically return to the previous temperature settings after the power is switched on again. Liquid Crystal Display (LCD) When you press any key, a...

Page 10 - Replacement of the fuse on the PCB controller; Drip Trays; Cleaning the Outside of the Unit

Warning: To avoid an electric shock, unplug the unit when replacing the energy-saving lamp. The lamp base is E27; the rated power of the lamp is 11W. Use a lamp of the same rating and size when replacing an energy-saving lamp. Remove the screw at the back of the lamp cover, then, to release the cove...

Page 11 - Cleaning the Inside; Troubleshooting

Cleaning the Inside Unplug the unit and remove all contents. Rinse the inside surface with plain water and dry the chrome shelves. Troubleshooting Unit does not turn on - First check to see if the unit is plugged in. A fuse could be blown or circuit breaker tripped. Noise or vibration Check that uni...

Page 12 - LCD displays “H” or ”L”

indicates that the actual temperature is much higher than your set temperature. Possible causes are: . The door might not be fully closed . The refrigerant may have leaked. . The magnet valve may not be functioning properly and should be replaced. If you are certain that the door is not the cause of...

Smeg SWC120X-1 - User Manual

Table of Contents:

Summary

Other Smeg Refrigerators Models