SMC Networks SMCG55 - Manual

Industry Canada - Class B This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the Department of Communications.Cet appareil numérique respecte le...

Environmental Statement The manufacturer of this product endeavours to sustain an environmentally-friendly policy throughout the entire production process. This is achieved though the following means:• Adherence to national legislation and regulations on environmental production standards. • Conserv...

Safety Compliance Underwriters Laboratories Compliance State-ment Important! Before making connections, make sure you have the correct cord set. Check it (read the label on the cable) against the following: The unit automatically matches the connected input voltage. Therefore, no additional adjustme...

Contents INTRODUCTION 1 Description of Hardware 1 Features and Benefits 1 Front Panel RJ-45 Ports 2 SMCGS5 Front and Rear Panels 3 SMCGS8 Front and Rear Panels 4 Rear Panel 4 INSTALLING THE SWITCH 5 Package Checklist 5 Selecting a Site 5 Instructions 6 APPLICATION EXAMPLE 8 TROUBLESHOOTING 9 SPECIFI...

EZ Switch 10/100/1000 1 INTRODUCTION The EZ Switch 10/100/1000, SMCGS5 and SMCGS8, are high-performance Gigabit Ethernet switches designed for delivering Gigabit connectivity to the desktop. It provides 5/8 full-duplex 1000BASE-T ports that significantly improve network performance and boost through...

EZ Switch 10/100/1000 2 Front Panel LEDs The front panel of the switch provides status LEDs for “at-a-glance” system monitoring. The following table details the functions of the various indicators. SMCGS5 Front and Rear Panels Port and System Status LEDsLED Condition Status Power On Power on, normal...

EZ Switch 10/100/1000 3 SMCGS8 Front and Rear Panels Rear Panel The DC power socket is located on the rear panel of the switch.

EZ Switch 10/100/1000 4 INSTALLING THE SWITCH Before installing the switch, verify that you have all the items listed under “Package Contents.” If any of the items are missing or damaged, contact your local SMC distributor. Also be sure you have all the necessary tools and cabling before installing ...

EZ Switch 10/100/1000 5 • There should be adequate space (approximately two inches) on all sides for proper air flow. • Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference such as radios, transmitters, etc. •...

EZ Switch 10/100/1000 8 T ROUBLESHOOTING Diagnosing Switch Indicators 1. Symptom Power LED does not light after power on. Probable Causes • DC power socket may be defective. Possible Solutions • Check for loose connections.• Check the power outlet by using it for another device. 2. Symptom Link LED ...

EZ Switch 10/100/1000 9 S PECIFICATIONS EZ Switch 10/100/1000 Standards Conformance IEEE 802.3IEEE 802.3uIEEE 802.3xIEEE 802.3ab Communication Rate 10, 100, and 1000 Mbps Communication Mode Full or half duplex at 10/100 MbpsFull duplex at 1000 Mbps Media Supported 10BASE-T: 100-ohm Category 3 or bet...