SMC Networks PRO-9675FT4 - Manual
SMC Networks PRO-9675FT4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION OF THE MAJOR COMPONENTS:
- Page 5 – YELLOW START WIRE DETAIL
- Page 8 – General Motors VATS By-Pass Diagram; key's value from the resistor pack supplied.
- Page 12 – Channel 3 Relay Wiring Detail
- Page 16 – ALARM SELECTABLE FEATURES
- Page 17 – To program these selectable features
- Page 18 – REMOTE START SELECTABLE FEATURES; certain to connect the tach input wire.
- Page 20 – ignition switch off. DO NOT attempt to remove the key.
- Page 21 – car should not start.; REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY
- Page 22 – METHOD 1; OF THE NEUTRAL SAFETY START FEATURE.
- Page 23 – mechanisms and impair the safe operation of the vehicle.
- Page 24 – WIRING DIAGRAM
4 Channel Remote Car Starter
With Full Feature Alarm System
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems,
Gasoline or Diesel With True Tach Reference
And Automatic Transmissions Only.
Kit Contents:
Remote Start/Alarm Control Module
(2) - Four Button Anti Code Grabbing Transmitters
4 Channel Code Learning Receiver
External Superheterodyne Antenna/Receiver
Mini Six Tone Siren
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Four Pin Auxiliary Output Harness
(1) - Two Pin LED Indicator
(1) - Two Pin Valet / Programming Switch
(1) - Two Pin Control Switch
(1) - Four Pin Shock Sensor Harness
(1) - Two Pin Door Lock Harness
(1) - Dual Stage Shock Sensor
(1) - Starter Inhibit Relay and Socket
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Pin Switch Hardware Bag
(2) - Under Hood Caution Labels
(1) - Installation Manual
(1) - Operator's Manual
(1) - Limited Warranty
(2) - Window Decals
Model PRO-9675FT4
Installation Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
The PRO-9675FT4 Remote Start/Alarm System is designed to be used with Automatic TransmissionVehicles Only! The unit provides a selectable ignition control that allows a number of selectable timed outputs for glow plug pre-heat which may be required for certain diesel vehicles, (see selectable featur...
BLUE Wire: Ignition 1 OutputConnect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when theignition key is turned to the "ON" or "RUN" and the "START" or "CRANK" positions, and will have 0 voltswhen the key is turned to the &#...
General Motors VATS By-Pass Diagram Light Blue Wire: Ignition 3 OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unitinitializes, and remains grounded while running plus an additional 4 seconds after the Remote Start Unitturns off. In all of the ap...
