Silvercrest SEKU 2000 A16 Manual

Page 2 - IE; Contents

1 SEKU 2000 A1 GB IE Contents Introduction . . . . . . . . . . . . . . . . . . . . . . 2 Information for these operating instructions . . . . . 2Copyright . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Limited liability . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Warnings ...

Page 3 - Introduction; Information for these operating instructions; Limited liability

2 Introduction SEKU 2000 A1 GB IE Introduction Information for these operating instructions These operating instructions are a component of the SEKU 2000 A1 Electric Fireplace (henceforth designated as the appliance) and they provide you with important information about the intended use, safety, ins...

Page 4 - DANGER; Intended use

3 Introduction SEKU 2000 A1 GB IE Warnings In these operating instructions the following warnings are used: DANGER A warning at this danger level indicates a threateningly dangerous situation. If the dangerous situation is not avoided, it could result in death or serious injury. Compliance with the ...

Page 5 - Safety; Do not cover the appliance!; Basic Safety Instructions

4 Safety SEKU 2000 A1 GB IE Safety In this chapter you are being given important safety information regarding the handling of the appliance. This appliance complies with the statutory safety regulations. Incorrect usage can, however, lead to personal and property damage. Do not cover the appliance! ...

Page 6 - Setting up and connecting; Safety Notices; Items supplied and delivery checks

5 Setting up and connecting SEKU 2000 A1 GB IE Defective components may only be replaced with original replacement parts. Only by using original ■ replacement parts can it be guaranteed that the safety requirements are being complied with. Protect the appliance from moisture and liquid penetration. ...

Page 7 - Before the fi rst use; Electrical connection

6 Setting up and connecting SEKU 2000 A1 GB IE Installation requirements For the safe and correct operation of the appliance, the installation site must satisfy the following requirements: The appliance must be placed on a ﬁ rm, ﬂ at and horizontal surface. ■ Do not place the appliance in a hot, wet...

Page 8 - Operating components

7 Operating components SEKU 2000 A1 GB IE Operating components NOTICE The operating elements are on the front of the appliance, above right and behind the ventilation grille. ► To operate them, fold the ventilation grille forward. ► ON/OFF switch (Flames) 2 ON/OFF switch (Heating, level 1) 3 ON/OFF ...

Page 9 - Set up; Individual parts of the electric fi replace

8 Set up SEKU 2000 A1 GB IE Set up Before the appliance can be set up, the ﬁ re surround must be assembled. NOTICE Check the contents to make sure everything is there and for visible damage. ► Firstly, become familiar with all parts involved in the assembly. ► Individual parts of the electric ﬁ repl...

Page 11 - Assembly

10 Assembly SEKU 2000 A1 GB IE Assembly Step 1 Screw three single locking pins D with a screwdriver into the prepared holes on the left front panel 2 . Place two wood plugs B into the holes of the front panel 2 . Insert three adapter sleeves E into the three large holes of the left side panel ...

Page 15 - Handling and operation; Switching the appliance on and off; Maintenance; Changing the light bulbs; Handling and operation/Maintenance

14 SEKU 2000 A1 GB IE Handling and operation NOTICE See also "Operating Elements" on page 7. ► In this chapter you receive important information for the handling and operation of the appliance. Activate the ON/OFF switch to turn the unit on. The ﬂ ame replication lights up. Programme in th...

Page 16 - Cleaning; Troubleshooting

15 SEKU 2000 A1 GB IE Switch the appliance oﬀ . Pull the plug from the mains power socket. Loosen the four screws on the rear panel and remove the metal ventilation panel 9 . Carefully replace the defective bulb 10 in the light shaft. Screw the metal ventilation panel 9 back onto the appli...

Page 17 - Storage

16 SEKU 2000 A1 GB IE Malfunction causes and remedies The following table will help with localising and remedying minor malfunctions: Defect Possible cause Solution The ﬂ ame replication does not light up. The appliance is not switched on. Switch the appliance on. The plug is not inserted. Insert th...

Page 18 - Appendix; Technical data; Notes on the EC Declaration of Conformity

17 Appendix SEKU 2000 A1 GB IE Appendix Technical data General Input voltage 220 - 240 V ~ Mains frequency 50 Hz Power consumptionHeating level 1Heating level 2 10002000 WW Bulb2 x Bulbs E14 2 x 25 W Ambient temperature +5 to +45 °C Humidity (no condensation) 5 to 90 % Measurements (W x H x D): 100 ...

Page 19 - Service; Importer

18 Appendix SEKU 2000 A1 GB IE Warranty You receive a 3-year warranty for this appliance as of the purchase date. The appliance has been manu-factured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase. In the case of a warranty claim, please make co...