Sharp CV-P09FR - Manual - manualsarea.com

Page 3 - ENGLISH; CONTENTS; Points to keep in mind when using your air conditioner.; WARNINGS FOR USE; • Always use a fuse with the proper amp rating.; WARNING FOR POWER SUPPLY CORD; conjunction with any extension cords.

ENGLISH ENGLISH This manual explains the proper use of your new air conditioner. Please read this manualcarefully before using the product. This manual should be kept in a safe place for handyreference. CONTENTS E-1 • IMPORTANT SAFETY INSTRUCTIONS ... E-1• LOCATION .....................................

Page 4 - USAGE CAUTIONS; NOTES ON OPERATION; IMPORTANT SAFETY INSTRUCTIONS; Mode; DEHUMIDIFICATION

USAGE CAUTIONS • Ventilate the room periodically during use, especially if using gas appliances.• Be sure to turn the unit off and disconnect the power supply cord before performing any maintenance or cleaning. • Do not splash or pour water directly onto the unit. Water can cause electrical shock or...

Page 5 - ENERGY EFFICIENCY TIPS; • Avoid direct sunlight.; LOCATION

ENGLISH E-3 ENERGY EFFICIENCY TIPS • Avoid direct sunlight. Close blinds, drapes or shades to keep out direct sunlight while in cooling mode. • Keep the filter clean. Keeping the filter clean greatly aids efficient operation.A dirty filter blocks the flow of air, making your air conditioner work har...

Page 6 - PART NAMES; REAR VIEW; FRONT VIEW

PART NAMES 1 Air Outlet 2 Vertical louvers 3 Horizontal louvers 4 PLASMACLUSTER Lamp (blue) 5 Remote control signal receiverwindow 6 AUX. Button 7 OPERATION Lamp (red ) 8 TIMER Lamp (orange ) 9 TURBO COOL Lamp (green ) 0 Air inlet REAR VIEW NOTE: Actual unit might vary slightly from above illustrati...

Page 7 - REMOTE CONTROL

ENGLISH REMOTE CONTROL 1 Transmitter 2 Display 3 ON/OFF Button 4 DISPLAY Button 5 TEMPERATURE Button 6 PLASMACLUSTER Button 7 1 hr OFF Button 8 MODE Button 9 ON TIMER Button 0 FAN Button q OFF TIMER Button w CANCEL Button e SWING Button r RESET Button t TURBO COOL Button E-5 y MODE SYMBOLS : COOL : ...

Page 8 - LOADING BATTERIES; USING THE REMOTE CONTROL

1 Remove the battery cover at the back of the remote control. 2 Insert batteries into the com- partment, making sure the ± ± ± ± ± and — — — — — polarities are correctly aligned. • Lines will appear on the display when batteries are properly in-stalled. 3 Reattach the battery cover. 4 Press the RESE...

Page 9 - CAUTION; HOW TO USE THE REMOTE CONTROL

ENGLISH E-7 CAUTION • Do not expose the signal receiver window to direct sunlight. This may adversely affect its operation. If necessary, close the curtains to block out the sunlight. • Use of a fluorescent lamp in the same room may interfere with transmission of the signal. • The unit may be affect...

Page 10 - Installation of the exhaust hose; Attach the insect guard net to the ex-; Unacceptable; INSTALLATION AND REMOVAL OF EXHAUST HOSE; Removal of the exhaust hose

The exhaust hose must be installed or removed in accordance with the usage mode. Mode Exhaust hose COOL, FAN, VENTILATION Install DEHUMIDIFICATION Remove Installation of the exhaust hose 1 Attach the insect guard net to the ex- haust adapter. Push the insect guard net firmly to ensure that four proj...

Page 11 - COOL MODE; TO TURN OFF

ENGLISH 1 3 COOL MODE Drainage nozzle Stopcock E-9 Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSEposition, and check the drainage nozzle is covered with the stopcock. 1 4 2 3 “CLOSE position” 1 Press the MODE button to select COOLmode. COOL DEHUM FAN VENT 2 Press the ON...

Page 12 - DEHUMIDIFICATION MODE; Press the MODE button to select DEHU-

DEHUMIDIFICATION MODE E-10 7 6 In this mode, the air conditioner dehumidifies the room. Drainage nozzle Stopcock Hose clamp Hose 1 Remove the exhaust hose (See Page 8) 2 Turn the drainage nozzle to the OPENposition. 3 Pull the stopcock out from the drainagenozzle. • When the stopcock is removed, a s...

Page 13 - FAN MODE

ENGLISH FAN MODE 1 5 2 3 VENTILATION MODE 1 4 5 2 3 E-11 Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSEposition, and check the drainage nozzle is covered with the stopcock. Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSEposition, and check t...

Page 14 - TO CHANGE AIR FLOW DIRECTION; UP/DOWN AIR FLOW DIRECTION; NOTE; LEFT/RIGHT AIR FLOW DIRECTION

TO CHANGE AIR FLOW DIRECTION UP/DOWN AIR FLOW DIRECTION NOTE • During VENTILATION mode, UP/DOWN air flow direction cannot be changed. Hold the vertical louver as shown in the dia-gram and adjust the air flow direction. 1 Press the SWING button on the remotecontrol. • The horizontal louvers will swin...

Page 15 - Press the TURBO COOL button again.; TURBO COOL OPERATION; Press the 1hr OFF button.; TO CANCEL; Press the CANCEL button.

ENGLISH E-13 1 Press the TURBO COOL button during coolingmode. • The remote control will display “ ” . • The temperature display will go off.• The green TURBO COOL lamp ( ) on the unit will light. TO CANCEL Press the TURBO COOL button again. • TURBO COOL operation is also cancelled when the mode is ...

Page 16 - NOTES ON TIMER SETTING AND OPERATION; TIMER OPERATION; OFF TIMER; Press the OFF TIMER (

0.5h 1.0h 1.5h 10h 11h 12h E-14 NOTES ON TIMER SETTING AND OPERATION • The latest time setting will be memorized and will appear on the remote control display the next time you set the OFF TIMER or ON TIMER. • The OFF TIMER and ON TIMER can not be set together. Only the most recent TIMER setting wil...

Page 17 - ON TIMER; Press the ON TIMER (

ENGLISH E-15 1 ON TIMER Display shown when you setthe unit to turn on 6.5 hourslater. The unit will turn on automatically according to your setting.Timer duration can be set from a minimum of half an hour (30 minutes) to a maximumof 12 hours.Up to 9.5 hours, you can set in half-hour (30-minute) incr...

Page 18 - Use this mode when the remote control is not available.; Press the PLASMACLUSTER button again.; PLASMACLUSTER OPERATION

AUXILIARY MODE AUXILIARY MODE 1 E-16 Use this mode when the remote control is not available. 1 Press the AUX. button on the unit. • The red OPERATION lamp ( ) on the unit will light and the unit will start operating inCOOL mode. • The fan speed is set to AUTO.• The temperature setting is automatical...

Page 19 - DRAINAGE

ENGLISH DRAINAGE Prepare for drainage and drain out water within the unit in the following cases. If the unit stops operating and the TIMER ( ), OPERATION ( ) and TURBO COOL ( ) lamps are blinking. (This indicates that the water tank inside the unit is full.) 1 Make sure to turn the unit off. 2 Turn...

Page 20 - CLEANING THE UNIT AND THE REMOTE CONTROL; MAINTENANCE; CLEANING THE INSECT GUARD NET; CLEANING THE FILTERS; REMOVE THE FILTERS; CLEAN THE FILTERS; REINSTALL THE FILTERS; MAINTENANCE AFTER AIR CONDITIONER SEASON

CLEANING THE UNIT AND THE REMOTE CONTROL Wipe them with a soft, dry cloth or with a cloth moistened with a mild soap. Carefully removeany residue by wiping with a damp cloth and dry completely.Avoid splashing water onto the unit. Water can dangerously damage the electrical insulation.Never use harsh...

Page 21 - BEFORE CALLING FOR SERVICE

ENGLISH BEFORE CALLING FOR SERVICE If the unit appears to be malfunctioning, check the following points before calling fora service. AIR CONDITIONER DOES NOT OPERATE AT ALL • Is the unit plugged in or is the plug loose?• Has the fuse blown or is the circuit breaker tripped?• Did you restart the unit...

Page 22 - SHARP CORPORATION

ENGLISH SHARP CORPORATION Osaka, Japan TINSEA419JBRZ 05AO TH 1 Printed in Thailand R

Sharp CV-P09FR - Manual

Table of Contents:

Summary

Other Sharp Models