Royal Sovereign 1650C - Manual

NO 123456789 10111213 ○ TAKE-UP BOBBIN IDLE BAR HOT ROLLER TABLE-FRONT UPPER ROLLER ○ ○ X TAKE-UP SWITCH ○ ○ PART NAME FRAME-GUIDE,PAPER RSC-1650H RSC-1650H NAMES OF MAJOR PARTS OF MACHINE CONTROL PANEL ○ FOOT SWITCH ○ ASS'Y-STAND PRESSURE LEVER TENSION CONTROL KNOB SAFETY COVER ○ REMOCON SWITCH ○ ○...

1. Set the glossy side of upper/lower film to face the heat. ( Glossy side is PET film and matte side is thermal polymer laminating film.) 2. Like picture 1, insert core into the left side of upper/lower film shaft.3. Like picture 2 and 3, insert core into the right side of upper/lower film. 4. Like...

1. Set up cold film below the upper bar of the machine. (Set the same as methord of the HOT film for protect paper of lower part) 2. Set the pressure lever to the 15mm, open mode. 3. Insert a piece of wide cardboard (guiding paper/carrier) between the rollers. 4. Pull the film from the upper roller ...

1. For setting, pull the pressure lever out and turn the lever to following the indication 2. OPEN/15mm(Board) : For laminating 15mm thick board (RSC-1650H/1650C) 3. 10~13mm(Board) : For laminating 10~13mm thick board 4. 5~7mm(Board) : For laminating 5~7mm thick board 5. 1mm(Hard Board) : For lamina...

We designed this machine standing by user’s convenience. You can manipulate speed and temperature . ***Terms*** INSTRUCTIONS FOR CONTROL PANEL 6 1 4 2 6 2 1 3 3 5 - 9 -

1. FUNCTIONS OF CONTROL PANEL RUN/STOP BUTTON : Run or stop the rollers SPEED BUTTON : Increase or decrease speed LED OF SPEED : Display or speed LED OF TEMP. : Display temperature TEMP.BUTTON : Increase or decrease temperature REVERSE BUTTON : To make the rollers run backward 2.HOW TO USE BUTTONS P...

1. Put cold roll film on upper bar.(Set the same as methord of the HOT film for protect paper of lower part)2. Pull COLD film, and fix it so that backside protecting paper can be wound on take-up mandrel clockwise. (Revolve core to make protectingpaper tight a little bit.)3. Set pressure lever at th...

**Cross Cutter** 1. It is on the back side of the machine. 2. After lamination, move cutter to a point about 1/3 of the width of lamination. 3. Grasp film with one hand and press the cutter, cutter downward and slide it to the direction intending to cut with another hand. 4.Press the cutter and slid...

CHECK POINT *Rollers do not operate 1. Check the power cord. after press RUN button 2. Check if the switch is on. 3. Check if the emergency switch is off. 4. Check the s/w of safety cover is right. *Wrinkled lamination 1. Adjust film tension. result 6 BOLT CORE 8 Washer( Φ 8) 6 Bolt(M8X12) 1. Power ...

1. For six month from the date of purchase, Royal Sovereign International Corporation or its authorized service center will repair this product free of charge if it is defective in material or workmanship. 2. This Limited Warranty does not include cleaning, or damage caused by accident, neglect, mis...