Rosewill R2-JBOD - Manual
Rosewill R2-JBOD – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Hardware Installation Guide; Release the 4 screws then pull out the rear panel and tray.
- Page 3 – Place the first HDD into the tray. Push the HDD to connect
- Page 4 – Screw the HDD on the tray both sides.
- Page 5 – HDD Formatting Guide; It enables each hard drive to be seen separately as single
- Page 6 – Select “Disk Management” and you will see your hard
- Page 8 – Right -click “My Computer” icon and select the “Manage”
- Page 9 – Two formatted HDDs; (These two HDDs have to be combined into one disk.
- Page 10 – Right-click the red-squared block and select “Initialize
- Page 11 – The external HDD will be showed “Online”. Right-click the
- Page 12 – When new partition is completed, the external HDD will be
[ R2-JBOD ]
External Enclosure
User Manual
Include
Hardware Installation Guide
HDD Formatting Guide
Thank you for purchasing a quality Rosewill Product.
Please register your product at : www.rosewill.com/ for complete warranty information and future support for your product.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
External enclosure Installation [ R2-JBOD ] User Manual 1 Hardware Installation Guide z Please follow the instructions and make sure your hard drive is successfully installed to the external enclosure! STEP1: Release the 4 screws then pull out the rear panel and tray.
External enclosure Installation [ R2-JBOD ] User Manual 2 STEP2: Place the first HDD into the tray. Push the HDD to connect e SATA connector. th STEP3: Place the second HDD into the tray. Push the HDD to connect the SATA connector. Note: Make sure all connectors are connected well.
External enclosure Installation [ R2-JBOD ] User Manual 3 STEP4: Screw the HDD on the tray both sides. STEP5: Push the tray into the aluminum case. Screw the rear panel and enclosure together.
