Rheem MPs Series- User Manual

Rheem MPs Series

Rheem MPs Series– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
Page: / 48

Table of Contents:

  • Page 2 – PATENTS; Rheem Australia Pty Ltd.; TRADE MARKS; Registered trademark of Rheem Australia Pty Ltd.
  • Page 3 – CONTENTS; HOUSEHOLDER – We recommend you read pages 4 to 19.
  • Page 4 – ABOUT YOUR WATER HEATER; WATER HEATER APPLICATION; Your Rheem; ELECTRIC BOOSTING
  • Page 5 – FREEZE PROTECTION; shown on page; HOW HOT SHOULD THE WATER BE?
  • Page 6 – WARNING; Do not use; aerosols, stain removers and household chemicals; near the water heater whilst it is; SAFETY
  • Page 7 – OPERATING MODE MONITOR; “Possible fault condition”; Time controlled power supply
  • Page 8 – Possible fault condition; There may be a fault condition with the water heater if either:; TIMER CONTROL; off, otherwise damage could result (refer to
  • Page 9 – TO TURN ON THE WATER HEATER; on page 5). If it is necessary to turn off the water; PRECAUTIONS; on page 11 and to; HOW DO I KNOW IF THE WATER HEATER IS INSTALLED CORRECTLY?; Installation requirements are
  • Page 10 – VICTORIAN CUSTOMERS; “Water Supplies”; HOW LONG WILL THE WATER HEATER LAST?; The water heater is supported by a manufacturer‟s warranty; ENVIRONMENT
  • Page 11 – REGULAR CARE; MINOR SIX MONTH MAINTENANCE; “Temperature Pressure Relief Valve”; MAJOR FIVE YEAR SERVICE; “Anode; HEAT PUMP SYSTEM
  • Page 12 – TEMPERATURE PRESSURE RELIEF VALVE; “Temperature; It is very important you raise and lower; Failure to do this may result in the water heater; EXPANSION CONTROL VALVE; It is very important you; The expansion control valve should be checked for performance or
  • Page 13 – WATER SUPPLIES; CHANGE OF WATER SUPPLY; “Major Five Year Service”
  • Page 15 – SAVE A SERVICE CALL; WATER NOT HOT ENOUGH; “Heat Pump Is Not Operating”
  • Page 16 – HEAT PUMP IS NOT OPERATING; Time controlled power supply (no power at the water heater); Heat pump fault condition; Refer to; Backup heating mode and series of red flashes; Fault Mode – 2 red LED flashes
  • Page 17 – “Heat Pump Start Up After Backup Heating Mode”
  • Page 18 – Green LED is off; “Thermal cut out activated”; TEMPERATURE PRESSURE RELIEF VALVE RUNNING; Normal Operation; “Temperature Pressure Relief Valve”; Steady flows for long periods (often at night); EXPANSION CONTROL VALVE RUNNING
  • Page 19 – HIGHER THAN EXPECTED ELECTRICITY BILLS
  • Page 20 – INSTALLATION; INSTALLATION STANDARDS; The water heater must be installed:; Victorian Installers; “Heat Pump and Tank Assembly”; tilt the heat pump module more than 30° from the vertical; . This will displace the compressor
  • Page 21 – WATER HEATER LOCATION; “Heat Pump and Tank Installation”
  • Page 22 – (refer to diagram on
  • Page 23 – HOT WATER DELIVERY; Two Temperature Zones Using a Temperature Limiting Device
  • Page 24 – CIRCULATED HOT WATER FLOW AND RETURN SYSTEM; The thermostat must always be set to at least 60°C. Refer to the; Temperature Limiting Device; Circulated Hot Water Flow and Return System
  • Page 25 – ANODE TYPES; “Anode”; SADDLING - PIPE WORK; TYPICAL INSTALLATION
  • Page 26 – DIMENSIONS AND TECHNICAL DATA; HEAT PUMP DIMENSIONS - REMOTE
  • Page 27 – HEAT PUMP AND TANK ASSEMBLY; STORAGE TANK AND HEAT PUMP MODULE; storage tank
  • Page 28 – KITS; Kit Installation Heat Pump Module Split
  • Page 29 – ASSEMBLY AND INSTALLATION PROCEDURE; Heat Pump Storage Tank:; Through the opening at the rear of the heat pump module:; Step 4
  • Page 30 – Heat Pump Module Location:; Select the location for the heat pump module.; Connection Side for Heat Pump Module:; Select which side, either the left or right hand side, of the; Step 7
  • Page 31 – Hose Bracket Assembly:; Step 8; Retrieve the four (4) sheet metal speed fasteners from the kit bag.; Step 9
  • Page 32 – Retrieve the heat pump module‟s rear access panel.; fix conduit clamp to heat pump module and locate cable set conduit; Position the slab or solid base to support the heat pump module.
  • Page 33 – Remove the template.; position template on the slab or solid base
  • Page 34 – Position Heat Pump Module:; right of its final location.; fix wall bracket tab to wall bracket; Non Return and Air Bleed Valve Assembly:; Connect the non return and air bleed valve assembly; connect non return valve
  • Page 35 – HEAT PUMP” on the heat pump storage tank.; connect insulated heat pump circuit pipe work to
  • Page 36 – Remove the lower front cover from the heat pump storage tank.; remove lower front cover; Cable Set Connection:; secure gland to electrical connection tab
  • Page 37 – Mains Power Connection:; connection inside of the lower front cover.; connect wiring; Refit the lower front cover.
  • Page 38 – “Connections – Plumbing”; connect hose to spigot; “Commissioning”
  • Page 39 – CONNECTION SIZES; Heat pump circuit connections on storage tank: RP1⁄2/15; WATER INLET AND OUTLET; “Hot; HEAT PUMP CIRCUIT
  • Page 40 – installation diagram on page; RELIEF VALVE DRAIN
  • Page 41 – CONDENSATE DRAIN
  • Page 42 – and a satisfactory megger reading is obtained.; MEGGER READING; MΩ for sheathed heating elements or appliances or; ELECTRICAL CONNECTION
  • Page 43 – “Freeze Protection”; BOOSTER HEATING UNIT AND THERMOSTAT SETTING
  • Page 44 – COMMISSIONING; TO FILL AND TURN ON THE WATER HEATER
  • Page 45 – TO TURN OFF THE WATER HEATER; Freeze Protection”; DIAGNOSTIC FEATURES OF THE HEAT PUMP CONTROLLER
  • Page 46 – DRAINING THE WATER HEATER
  • Page 47 – RHEEM HEAT PUMP WATER HEATER WARRANTY; THE RHEEM WARRANTY; TERMS OF THE RHEEM WARRANTY AND EXCLUSIONS TO IT
  • Page 48 – Revision Date: 2012 January; ENTITLEMENT TO MAKE A CLAIM UNDER THIS WARRANTY; Australian Consumer Law
Loading the manual

This water heater must be installed and serviced by a qualified person.

Please leave this guide with the householder.

Owner’s Guide

and

Installation Instructions

Air Sourced Split Heat Pump

Water Heater

MPs Series

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - PATENTS; Rheem Australia Pty Ltd.; TRADE MARKS; Registered trademark of Rheem Australia Pty Ltd.

PATENTS This water heater may be protected by one or more patents or registered designs in the name of Rheem Australia Pty Ltd. TRADE MARKS ® Registered trademark of Rheem Australia Pty Ltd. ™ Trademark of Rheem Australia Pty Ltd. Note: Every care has been taken to ensure accuracy in preparation of ...

Page 3 - CONTENTS; HOUSEHOLDER – We recommend you read pages 4 to 19.

3 CONTENTS HOUSEHOLDER – We recommend you read pages 4 to 19. The other pages are intended for the installer but may be of interest. About Your Water Heater ............................................................................................................ 4 Regular Care ......................

Page 4 - ABOUT YOUR WATER HEATER; WATER HEATER APPLICATION; Your Rheem; ELECTRIC BOOSTING

4 ABOUT YOUR WATER HEATER WATER HEATER APPLICATION This water heater is designed for use in a single family domestic dwelling for the purpose of heating potable water. Its use in an application other than this may shorten its life. MODEL TYPE Your Rheem ® air sourced split heat pump storage tank is ...

Other Rheem Models