Quasar PAG - Manual
Quasar PAG – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SPEC IF ICAT ION; SEC T ION 2; Range of Batteries Charged:; Ancillary Charging Programs:
- Page 3 – AC Mains Failure Protection:; Operating Temperature Range:; INSTALLATION; SEC T ION 3
- Page 4 – OPERATING INSTRUCTIONS; SEC T ION 4; POWERING UP
- Page 5 – CONNECTING A BATTERY; Charger set to Manual Selection:; RECOVERY CHARGE
- Page 6 – SUPPLY FAILURE; To exit Power Supply Mode:; GENERAL; SEC T ION 5
- Page 7 – PAG Quasar; two years; WARRANT Y; SECTION 6
U5047A PAG QUASAR INSTRUCTION MANUAL
U5047A PAG QUASAR INSTRUCTION MANUAL
Instruction Manual
CONTENTS
SECTION
PAGE
1
SAFETY
2
2
SPECIFICATION
3
3
INSTALLATION
6
4
OPERATING INSTRUCTIONS
7
5
SERVICING & REPAIRS
1 2
6
WARRANTY
1 4
PAG Quasar
All-Chemistry Charging System
SAFET Y
SEC T ION 1
1.1
This manual contains important safety and operating instructions.
Please read these fully and note all warnings before using the charger.
Please follow all instructions and retain this manual for future
reference.
1.2
PAG Quasar chargers are not intended for any use other than the
charging of batteries and the powering of broadcast cameras as
detailed in Section 2 , Specification, Page 3.
1.3
IMPORTANT:
Use only on AC supplies 100V-250V, 47-63Hz or with
PAG approved voltage converters. Connection of the supply to the
unit should be made using only the standard lead provided with this
equipment.
1.4
Protect the power cord from being walked on or pinched. Unplug this
apparatus during lightning storms or when unused for long periods of
time.
1.5
Ensure that the ventilation slots are not obstructed when in use, e.g.
do not site the charger on a carpet, or cover when in use.
1.6
WARNING:
Indoor use only. To reduce the risk of fire or electric
shock, do not expose this apparatus to rain or moisture.
1.7
Although the charger is reverse polarity and short circuit protected,
extreme care should always be taken not to short circuit the battery
itself. Rechargeable batteries can deliver power at a very high rate,
and short circuiting even a partially charged battery could result in a
fire or personal injury. PAG supplies a range of connector leads for
most charging requirements, and does not accept responsibility for
any other form of charging connection.
1.8
Do not disassemble the charger. There are no user-serviceable parts
inside. Incorrect re-assembly may result in a safety hazard.
1.9
Double Insulation: When servicing use only identical replacement parts.
1
2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
U5047A PAG QUASAR INSTRUCTION MANUAL U5047A PAG QUASAR INSTRUCTION MANUAL SPEC IF ICAT ION SEC T ION 2 2.1 PAG Quasar range: Model No. 9726 ◗ Two PAGlok connectors and two PP90 (2.1mm) connectors. Model No. 9727 ◗ Two Snap-on compatible connectors and two PP90 (2.1mm)connectors. Model No. 9752 ◗ Two...
U5047A PAG QUASAR INSTRUCTION MANUAL U5047A PAG QUASAR INSTRUCTION MANUAL ◗ Self-adjusting Maintenance Charge (not applied to PAG Li-Ionbatteries). 2.7 Self Test Program: The internal microcomputer constantly monitors the battery undercharge or process as well as the operation of the charger’s ownfu...
U5047A PAG QUASAR INSTRUCTION MANUAL U5047A PAG QUASAR INSTRUCTION MANUAL OPERATING INSTRUCTIONS SEC T ION 4 4.1 POWERING UP Connect the charger to a suitable supply using the standard leadsupplied. The LCD screen will illuminate and briefly display the PAGlogo and charger model before entering norm...
