QLogic MPX100 - Manual
QLogic MPX100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – admin start; . The default password is; command at the; Password : config; set mgmt; All attribute values that have been changed will now be saved.
- Page 3 – show mgmt
- Page 5 – image unpack; when prompted to reboot.; show system
- Page 6 – set system; to change the mode to data migration; Changes to the Settings below will be effective after a reboot.; yes
- Page 7 – Change the mpx100 mode from iSCSI Connectivity to Data Migration:; System Mode Data Migration
- Page 8 – only valid way to obtain the mpx100 serial number.
- Page 10 – Document Revision History; Changes
HP0051401-00 A
1
Applications Note
Converting mpx100 to HP
®
Data Migration Appliance
To convert an mpx100 to an HP data migration appliance, follow these steps:
1. Reset factory defaults:
If the mpx100 unit has been previously used, it must be reset to the factory defaults. If the mpx100 is
.
To reset the router and restore it to the factory default configuration, use a pointed, nonmetallic tool
to press and hold the maintenance button until the heartbeat LED flashes 20 times, then release the
button. The router boots and is restored to the factory defaults. The boot time is less than one minute.
shows the LEDs and maintenance button.
Figure 1. LEDs and Maintenance Button Locations
2. Configure access to the mpx100 management port:
a. Connect the router’s 10/100 Ethernet port to your workstation using a switch or hub. Alternatively,
connect your workstation directly to the router using an Ethernet crossover cable. The mpx100’s
management port’s default IP address is
10.0.0.1
subnet
255.0.0.0
.
b. Make sure the workstation connected to the mpx100 router has Ethernet address
10.0.0.
x
,
where
x
is other than
1
and the subnet mask is
255.0.0.0
.
c. From the workstation, open a command window. Using a telnet session, connect to the mpx100
using IP address
10.0.0.1
. Login as
guest
and enter the password
password
. The Command
Line Interface (CLI) prompt displays (
mpx100 #>
).
Product Affected
Device Name
Part Number
mpx100
AE324-63003
1. HEARTBEAT LED
2. POWER LED
3. SYSTEM FAULT LED
4. MAINTENANCE BUTTON
1
2 3
4
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Configure access to the mpx100 management port: HP0051401-00 A 2 A d. Enter the CLI command admin start . The default password is config . e. Enter the set mgmt command at the mpx100 (admin) #> prompt. f. Select the mode. QLogic recommends static address mode, which is IPv4 Mode 0 [Static] (this ...
Configure access to the mpx100 management port: HP0051401-00 A 3 A i. Verify that the IP address is set correctly by typing the show mgmt command. mpx100 (admin) #> show mgmt Management Port Information ----------------------------- IPv4 Interface Enabled IPv4 Mode Static IPv4 IP Address 172.17.1...
Upgrade mpx100 with data migration firmware: HP0051401-00 A 5 A k. Unpack the image by typing the image unpack command. Enter yes when prompted to reboot. l. When the mpx100 is finished rebooting, verify that the new firmware loaded successfully by typing the show system command. mpx100 (admin) #>...
