QLogic MPX100 - Manuals

QLogic MPX100 – Manual in PDF format online.

Manuals:

Manual QLogic MPX100

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10

Summary

Page 2 - admin start; . The default password is; command at the; Password : config; set mgmt; All attribute values that have been changed will now be saved.

Configure access to the mpx100 management port: HP0051401-00 A 2 A d. Enter the CLI command admin start . The default password is config . e. Enter the set mgmt command at the mpx100 (admin) #> prompt. f. Select the mode. QLogic recommends static address mode, which is IPv4 Mode 0 [Static] (this ...

Page 3 - show mgmt

Configure access to the mpx100 management port: HP0051401-00 A 3 A i. Verify that the IP address is set correctly by typing the show mgmt command. mpx100 (admin) #> show mgmt Management Port Information ----------------------------- IPv4 Interface Enabled IPv4 Mode Static IPv4 IP Address 172.17.1...

Page 5 - image unpack; when prompted to reboot.; show system

Upgrade mpx100 with data migration firmware: HP0051401-00 A 5 A k. Unpack the image by typing the image unpack command. Enter yes when prompted to reboot. l. When the mpx100 is finished rebooting, verify that the new firmware loaded successfully by typing the show system command. mpx100 (admin) #>...

QLogic Manuals