Pyle PP-5200 - Manual
Pyle PP-5200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Warranty Limits; Copyright Posiflex Inc. 2005
- Page 3 – Table Of Contents; GETTING STARTED; MAINTENANCE GUIDES; MAINTENANCE GUIDE LINES
- Page 4 – ii; SPECIFICATIONS
- Page 5 – CONGRATULATION; You have made a very wise decision by purchasing the easy; PRODUCT BRIEFING; The Aura PP-5000 series support two types of interface
- Page 6 – kitchen bell; UNPACKING; Be sure
- Page 8 – INDICATORS; Rear View
- Page 9 – LOADING PAPER; Desk top application
- Page 10 – When to replace paper; Whenever the printer gives paper out signal or a red line; CONNECTING CABLES; Serial connection; All the external connectors are in the recessed area at the; switch positions both 1, and 2 to OFF leaving the; Parallel connection; The parallel connector is a 25 pin D sub Male connector at
- Page 11 – Peripheral connection; The peripheral controller is a 6 pin RJ11 jack between the; Power connection; The power connector is a 3 pin jack at the rightmost; CAUTION: Before doing the insertion or extraction of the
- Page 12 – Power on; When all the above cable connections are made correctly,; Self test; Press and hold down the feed button while turning the
- Page 13 – SPECIAL ADJUSTMENTS; Paper near end sensor
- Page 14 – Paper cutting; The paper advance after a protective cut is now set to 12; Wall mount application; In wall mount application, the option kit will include screws
- Page 15 – III. MAINTENANCE GUIDES; Please use soft hair brush or compressed air to clear away; PRINT HEAD CLEANING; The print head is located underneath the roll paper passage; NOTE: Never do this when print head is still hot; Thermal Elements
- Page 16 – TROUBLE SHOOTING; General Problems; No LED lights up on con trol panel when switched on; Printing Problems; Nothing can be printed with ERROR LED ON
- Page 18 – Paper Jam Problems; Paper is jammed inside the printer; Auto Cutter Problems
- Page 20 – Advanced Analysis Tool; Hexadecimal Dump
- Page 21 – IV. SPECIFICATIONS; PRINTER; ITEM; PAPER
- Page 22 – POWER ADAPTOR
- Page 23 – V. TECHNICAL INFORMATION; INTERFACES; Peripheral interface; Description
- Page 24 – Serial interface; The serial interface cable is a RJ45 plug to DB9F cable of; DB9F; SETUP WINDOW; On bottom cover of the Aura series thermal printer, there is
- Page 26 – ADVANCED SETTINGS
- Page 28 – Do not use a power outlet of a circuit shared with any
Rev.: A0
Aura Series
(PP-5000 / PP-5200)
Thermal Printer
User's Guide
IMPORTANT!!!!
Please read carefully before using this printer
Before opening the Top Hood, make sure there is no
paper jam or cutter jam trouble. (Read page 3-4,
3-5 and Warranty Limit in the user’s Manual.)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P/N: 19740900010 Federal Communications Commission Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limit s are designed to provide reasonable protection against harmful...
i Table Of Contents GETTING STARTED . . . . . . . . . . . . . . . . . . . . . 1 -- 1 CONGRATULATION . . . . . . . . . . . . . . . . . . . . . . 1 -- 1 PRODUCT BRIEFING . . . . . . . . . . . . . . . . . . . . . 1 -- 1 UNPACKING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 -- 2 OPTIONS ...
ii Printing problems . . . . . . . . . . . . . . . . . . . . .3 -- 2 Paper jam problems . . . . . . . . . . . . . . . . . . . 3 -- 4 Auto cutter problems . . . . . . . . . . . . . . . . . . 3 -- 4 Advanced analysis tool . . . . . . . . . . . . . . . . .3 -- 6 SPECIFICATIONS . . . . . . . . . . . . ....
