Pyle PLVWAN1 - Manual
Pyle PLVWAN1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Powered Diversity TV Antenna
P LV WA N 1
Installation Manual
Proper Location
Mount the antenna on the inside rear window of the car.
F o r o p t i m u m r e c e p t i o n , m o u n t t h e a n t e n n a p o i n t i n g
down.(See Fig 2)
Leave a minimum of 1 inch space between the antenna
wires and the edge of the window.
Location should not impair driver s view.
Location should not impair driver s view.
Do not mount near or next to an existing antenna.
Be certain that there is enough cable to reach the unit.
Trial fit the antenna-do not remove protective paper from
booster or antenna sections.
(Fig 2)
Parts Supplied
1. TV Antenna(2)
2. Power Cord Holder(6)
3. Antenna Cable Holder(4)
4. Cigarette Light Plug(1)
5. Seal(2)
1. TV Antenna(2)
2. Power Cord Holder(6)
3. Antenna Cable Holder(4)
4. Cigarette Light Plug(1)
5. Seal(2)
Note:
1. Use only on vehicles with 12-14.4 Volt batter y
2. Avoid short circuits by disconnecting the negative(-)batter y
cable before beginning installation.
3. Protect the wiring by wrapping adhesive tape around
exposed areas.
4. Antenna wires should not get in contact with moving
parts, areas of hot or sharp sur faces.
5. Avoid installing in areas that may get wet with rain.
Failure to do so may result in fire or electrical shock.
Antenna
Loading coil
Antenna cable
Antenna plug
Booster amp section
Power cord
(Fig 1)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
