Pyle PLTV64R - Manual

5 MOUNTING THE TUNER UNIT 1. Bracket (A)2. Mounting Bolt (M5 x 5)3. Bracket (B)4. Hexagonal Bolt with Washer (M6 x 12)5. Tapping Screw with Washer (M5 x 12)6. Spring Washer (M6)7. Spring Washer (M5)8. Double Sided Tape INSTALL THE DISPLAY UNIT Before install the display unit, pleaseremove its tail s...

6 Removing the unit 1. Lever Insert the levers supplied with the unitinto the grooves at both sides of the unit as shown in figure until they click.Pulling the levers upward and out to makes it possible to remove the unit. DIN REAR-MOUNT Installation using the screw holes on theboth sides of the uni...

CAUTION: 1. If the TV control grey cable is connected to car brake, when the car is running, you cannot switch into TV mode, and the button (2) or (OPEN/CLOSE) button (31) is unavailable. 2. To select CD changer’s sort: Before installing the unit, connect the CD changer with the unit correctly and t...

8 LOCATION AND FUNCTION OF KEYS OPERATION 10 4 3 8 4 5 7 1 6 14 11 12 13 15 19 20 18 17 21 16 9 2

GENERAL OPERATION • ON/OFF Switch on the unit by pressing PWR button (1). When system is on, press it again to turn it off. • SELECTING SOUND MODE Press SEL button (6) to move display through volume, bass, treble, balanceand fader functions. Use VOL (7) and VOL (8) buttons to adjust the selected mod...

11 OPERATION RADIO OPERATION • SELECTING BAND Press BND button (11) to change between three FM bands and two AMbands and one LW band. Each band stores up to six preset stations. • SELECTING STATION During radio mode, press TUNE/SKIP button (13) to increase frequency or TUNE/SKIP button (14) to decre...

OPERATION TV OPERATION • REMOTE SENSOR On the screen display, there is a remote sensor IR (10) to receive remote control signal. You can point the remote control handset to IR (10) and press function keys on the handsetto control TV.The unit is also connected an externalremote receiver (See the elec...

13 OPERATION In this case, you also need to consider if the IR (10) is available. - When the display turns downward to a certain angle, it will draw in. • SELECTING RECEIVING MODE Press TV/AV button (22) to select among AV1/AV2/TV. • SELECTING CHANNEL - Press CH + button (28) or CH – button (29) to ...

14 OPERATION • VOLUME ADJUSTMENT Press VOL + button (32) or VOL – button (33) to adjust volume level. • MUTE Press MUTE button (25) to mute the sound. Press the button again, the screen will display “VOLUME XXX” forabout 4 seconds, and this is the AUDIO level setting value of the TV unit. The users ...

SPECIFICATION 15 GENERAL P ower Supply Voltage : DC 12 Volts, Negative Ground Maximum P ower : 4 x 60 Watts Load Impedance : 10 Ampere (max.) Tone Controls- Bass (at 100 Hz) : + / – 10 dB - Treble (at 10 KHz) : + / – 10 dB TV Monitor Screen Size : 6.4” TFT Resolution : 960 x 234 dots TV Sensitivity ...