Page 2 - FEATURES; • A single LSI chip now integrates all; USE THIS PRODUCT SAFELY; • The monitor is operated automatically.
2 FEATURES Compatible with PAL DVD (VideoCD) and NTSC DVD (Video CD) This player can play discs recorded ineither PAL or NTSC format. • A single LSI chip now integrates all major DVD playback circuit functions including MPEG2 decoder, video D/A converter, and audio decoders. • L/R stereo analog audi...
Page 3 - CONTENTS
Safety Information ......................................................................................................4 Disc Notes ...................................................................................................................5 Installation .......................................
Page 4 - SAFETY INFORMATION
4 CAUTION: MOBILE DVD PLAYER IS A CLASS ILASER PRODUCT. HOWEVER THISMOBILE DVD PLAYER USES AVISIBLE/INVISIBLE LASER BEAMWHICH COULD CAUSE HAZARDOUSRADIATION EXPOSURE IF DIRECTED.BE SURE TO OPERATE THE MOBILEDVD PLAYER CORRECTLY ASINSTRUCTED.USE OF CONTROLS ORADJUSTMENTS OR PERFORMANCE OFPROCEDURES O...
Page 5 - DISC NOTES; will cause misoperation.
DISC NOTES 5 Disc formats supported by this player DVD 12 cm disc(Single-sided disc only) VIDEO CD 12 cm disc CD 12 cm disc MP3 12 cm disc Discs which cannot be played with thisplayer • DVD-ROM• DVD-R/DVD-RAM• CDV• CD-G Handling and Cleaning • Dirt, dust, scratches and warping disc will cause misope...
Page 6 - INSTALLATION; Installation Opening
6 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use o...
Page 7 - Removing the unit
6. Reconnect the wire harness and the antenna and be careful not to pinchany wires or cables. 7. Slide the unit into the sleeve until it locks into place. 8. To further secure the unit, use the supplied metal strap to secure the backof the unit in place. Use the suppliedhardware (Hex Nut (M5mm) and ...
Page 8 - THE PLAYER; FRONT VIEW; POWER; Closed Position
THE PLAYER FRONT VIEW 1. POWER 7. PICT 2. Remote sensor (on the front panel) 8. Adjust (-) 3. OPEN/CLOSE 9. Adjust (+) 4. (EJECT button) 10. Remote sensor (on the monitor panel) 5. DISC SLOT 11. 6.5 INCH COLOR 6. RESET BUTTON TFT MONITOR Closed Position Open Position 9 5 1 6 2 4 3 7 8 9 10 11 8
Page 9 - BACK VIEW
12. 13-PIN SOCKET 15. AUDIO/ VIDEO INPUT 13. RGB SYSTEM 16. DIGITAL AUDIO 14. REMOTE SOCKET 17. DC 12V IN THE RADIO BOX 9 THE PLAYER BACK VIEW 1. 20-PIN SOCKET2. TO MAIN UNIT3. VIDEO OUTPUT 4. AUDIO OUTPUT5. ANTENNA SOCKET6. DIVERSITY ANTENNA ONE SIDE 12 13 14 15 16 17 2 3 1 4 5 6 ANOTHER SIDE
Page 10 - ELECTRICAL CONNECTION; DVD UNIT; RADIO BOX
10 ELECTRICAL CONNECTION RADIO BOX 0.5A ACC (RED) GND (BLACK) CHOKE BOX DIGITAL AUDIO DVD UNIT REMOTE AUDIO/VIDEO INPUT DC 12V IN (BLACK) RGB SYSTEM ONE SIDE RADIO BOX FUSE FRONT RCA CABLE (BROWN) REAR RCA CABLE (GREY) WHITE RED WHITE Lch Rch Lch RED Rch ANTENNA SOCKET OTHER SIDE FRONT LchSPEAKER RE...
Page 11 - REMOTE CONTROL; LOCATION AND FUNCTION OF KEYS
11 REMOTE CONTROL LOCATION AND FUNCTION OF KEYS 6 1 3 7 11 35 4 10 36 5 12 13 14 2 8 9 16 15 17 20 18 19 24 34 22 28 23 25 21 32 26 27 30 31 29 33
Page 13 - Preparing the Remote Control; Inserting the Batteries; LOADING/EJECTING A DISC; Loading a Disc; Turn the ignition on the accessory; Insert the disc with printed side facing; Ejecting a Disc
13 REMOTE CONTROL Preparing the Remote Control Inserting the Batteries 1. Open the battery compartment cover.2. Insert the new batteries. Make sure that the positive and negative terminals of the batteries are orientedas indicated. 3. Close the cover • Battery: Two AAA size battery Using the Remote ...
Page 14 - OPERATION; BASIC OPERATION; Turnig the player on/off
14 OPERATION BASIC OPERATION Turnig the player on/off Press the POWER button on the front panel or (POWER) button on the remote control to turn the player on oroff. Open/Close the Monitor and AngleAdjustment • Press OPEN/CLOSE button on the front panel or point the remote controlto remote sensor on ...
Page 18 - On-Screen Display Function
On-Screen Display Function Press the DISPLAY button during playback to display the contents of thecurrent disc on the screen.Example: DVD: (1) Press DISPLAY for the first time: TITLE 01/03 CHAPTER 002/025 00:02:25 Title Number, Total Title Number, ChapterNumber, Total Chapter Number of thisTitle of ...
Page 19 - Multi-audio Language Function
19 between monaural and stereo sound. MONO LEFT MONO RIGHT STEREO MENU Function (For DVD Only) Press MENU button while the disc is playing and the disc root menu will bedisplayed. You can navigate with theremote control navigation keys andselect a feature with the ENTER key. TITLE Menu Function (For...
Page 20 - Smart navigation in MP3 Play; RADIO OPERATION
20 Smart navigation in MP3 Play MP3 disc is playing as the format ofFOLDER.For example: In stop mode, use / , / on theremote control to select the item or folder(such as CD01, CD02...) and press ENTER button on the remote control to confirm, then select the desired track(such as 001 PLUMT, 002 RZID....
Page 22 - AV OPERATION
22 appears on the display, you can press“1 “button then press “6” button toselect 16 channel. • Mute Press MUTE button on remote control to cut down sound output.Press it again to resume the previousvolume mode. • Screen display Press TITLE (DSP) button on remote control to display the current statu...
Page 23 - SETUP; INITIAL SETUP
23 SETUP INITIAL SETUP SETUP MENU --- MAIN PAGE 1. Press SETUP on the remote control in the stop mode.(Press the buttontwice to ensure that the player is inunder STOP mode.) 2. The initial SETUP menu is displayed. 3. Select the preferred item by using the / buttons. 4. Press ENTER button. a. GENERAL...
Page 24 - PIC mode setup
24 SETUP --- GENERAL PAGE --- PIC mode setup Select AUTO, the player PIC mode willdepend on DVD disc.Select HI-RES format for best imageresolution.Select N-FLICKER format on image orpicture with noise or distortion. --- GENERAL PAGE --- ANGLE MARK display setup If it is set to ON, when the multi-ang...
Page 25 - SCR SAVER setup; SPEAKER SETUP; AUDIO OUT
25 SETUP --- GENERAL PAGE --- SCR SAVER setup Select the SCR SAVER ON/OFF. SPEAKER SETUP --- SPEAKER SETUP PAGE --- This is to activate the audio output fromDOLBY AC3 5.1 DOWNMIX to 2 channelmode. Select the preferred SPEAKERconnection by using the cursor buttons.- Select the LT/RT to activate the D...
Page 26 - PREFERENCES SETUP; TV type setup
26 SETUP PREFERENCES SETUP --- PREFERENCES PAGE --- TV type setup This player can play discs recorded ineither PAL or NTSC format.Select NTSC format, when the unit isconnected to NTSC TV.Select PAL format, when the unit isconnected to PAL TV.Select AUTO format, the player TV outputformat will be acc...
Page 27 - SUBTITLE language setup
27 SETUP --- PREFERENCES PAGE --- SUBTITLE language setup Select the preferred SUBTITLE languageby using the cursor buttons. --- PREFERENCES PAGE --- DISC MENU language setup Select the preferred DISC MENUlanguage by using the cursor buttons. --- PREFERENCES PAGE --- PARENTAL Select suitable parenta...
Page 28 - DEFAULTS; DEFAULTS TABLE
28 SETUP --- PREFERENCES PAGE --- DEFAULTS Select reset to revert to factory initialsettings. --- PREFERENCES PAGE --- SMART NAV If selected WITH MENU mode, whenplaying an MP3 disc, the smartnavigation menu will appear on thescreen, then the user can select a trackto play according to the menu hint....
Page 29 - TROUBLE SHOOTING
TROUBLE SHOOTING If it appears that your DVD unit is faulty,first consult this checklist. It may be thatsomething simple has been overlooked. Under no circumstances should youtry to repair the player yourself, as thiswill invalidate the warranty. Onlyqualified service personnel canremove the cover o...
Page 30 - SPECIFICATIONS
SPECIFICATIONS GENERAL Power Supply Requirements : DC 12 Volts, Negative GroundMaximum Output Power : 4x40 watts Current Drain : 15 Ampere (max.) TV TV Sensitivity : 45dB µ V @CH25 in average RADIO FM Frequency Coverage : 87.5 to 107.9 MHz Sensitivity (S/N=30dB) : 4 µ V Image Rejection : >45dB St...
Page 31 - MOBILE TV TUNER UNIT
Page 32 - CONTROL & FUNCTION KEYS; POWER INDICATOR LIGHT
88-V1953-09 www.pyleaudio.com CONTROL & FUNCTION KEYS This unit can’t be used separately and it must be used with other special system withthe 13-pin cable. The unit is connected to another system through the 13-pin dinsocket (3). And the unit can receive TV signal through the antenna input jack...
Page 34 - driving function of the driver .
2 INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system works properly. • Use...
Page 36 - USING THE DETACHABLE FRONT PANEL; To Detach the Front Panel; Remove the front panel by pulling its middle hand outward.
USING THE DETACHABLE FRONT PANEL To Detach the Front Panel 1. Press the open button (open), then the front panel will be folded down. O p e n F r o n t P a n e l 2. Remove the front panel by pulling its middle hand outward. 3. For safekeeping, store the front panel in the supplied protective case im...
Page 37 - Do not attempt to disassemble the front panel.
5 To Reinstall the Front Panel 1. Push the front panel into the main body, A 'click' sound should be heard. 2. Note that if the front panel fails o lock in position properly, press control button may not function and LCD display may be missing some segments. Pushing the open button and then reinstal...
Page 38 - WIRING CONNECTION; MAIN UNIT
6 WIRING CONNECTION GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) REAR RCA CABLE ANTENNA CONNECTOR RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B-) MEMORY BACK-UP IGNITION ...
Page 39 - GENERAL OPERATION; FACEPLATE RELEASE
7 OPERATION ON/OFF (FOR VFD VERSION ONLY) Switch on the unit by pressing any button (except EJECT button (4) and REL button (7)).When system is on, press ILL/PWR button (9) shortly to adjust the brightness of the VFDdisplay, press it for several seconds to turn off the unit. 5 4 28 30 29 11 17 7 13 ...
Page 41 - BAND SELECTION; STATION SELECTION
9 RADIO OPERATION BAND SELECTION At tuner mode, press BND/LOU button (13) shortly to select the desired band.The reception band will change in the following order: FM1 FM2 FM3 AM STATION SELECTION Press TUNE/SEEK button (16) or TUNE/SEEK button (17) shortly to activateautomatic seek function. Press ...
Page 43 - SPECIFICATION; GENERAL; FM
11 SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 155 (D) x 50 (H) Tone Controls- Bass (at 100 Hz) : 10 dB - Treble (at 10 KHz) : 10 dB Maximum Output Power 10 ampere (max.) Current Drain TAPE PLAYER Tape Speed : 4.76 cm/sec Fast Forward...
Page 44 - T R O U B L E S H O O T I N G; C A U T I O N; Metal parts of this unit (especially on; Symptom
1 2 T R O U B L E S H O O T I N G The following checks will assist in the reaction of most problems which you may counter with your unit. Should any problem persest after you have made these check, consult your nearest service dealer.Before going through the check list be first refer back to the con...
Page 45 - For System; For Tape Player
For System The following suggestions help you care for the product so that you can enjoy it for years.1. Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. 2. Keep the product away from dust and dirt, which can ...
Page 46 - Ignition
1. This unit is designed to operate on 12-volts DC, negative ground electrical system only. Do not attempt to install this unit in a vehicle having a positive ground system.2. You should not touch the high-polished playback head with any metallic or magnetic tools.3. Your unit has built-in filtering...
