Pyle PLNVB26 - Manual - manualsarea.com

Page 2 - SAFETY INSTRUCTIONS

Please read this section carefully and follow all the instructions given. This will helpensure reliable operation and extend the service life for your appliance.• Keep the packaging and the user instructions for future reference or inquiries.1) Never open up the housing of the appliance, it contain ...

Page 4 - INSTALLATION

4 INSTALLATION • Mounting The Navigation Set In A Car Use 4 screws ( 5X25) to install the navigation set to the car, please refer to the followed diagram.

Page 5 - ACCESSORIES

5 ACCESSORIES • GPS BOX • GPS ANTENNA • REMOTE SENSOR • SD CARD • SCREW 5X25 (4 PCS) • RGB TO RGB CABLE • RGB TO RCA VIDEO LINEOUT • REMOTE CONTROL

Page 6 - GPS BOX

1. GPS ANT (GPS Antenna, To receive GPS signal.) 2. Socket (Connect GPS Box And The Unit) 3. RGB/VIDEO Switch (Switch between RGB mode and VIDEO mode.) 4. RESET (Reset Button) 5. PWR (Power Indicator LED) 6. SD (SD Card Interface) 6 GPS BOX 2 1 One Side Other Side 6 3 4 5

Page 7 - REMOTE CONTROL

7 REMOTE CONTROL 1. ESC Press it to exit the current menu. 2. (ENTER) Press it to enter the selected item. 3. / , / These buttons serves as navigation-pad, moves up / down / left / right by pushing the corresponding area of the pad. 4. VOL+/- Press VOL+/- buttons to increase/decrease the sound. 5. Z...

Page 8 - ELECTRICAL CONNECTION

8 ELECTRICAL CONNECTION Wiring (1) Wiring (2) EXTERALANTTENA GPS BOX 20 PIN GPS BOX EXTERALANTTENA RGB OUT RCA OUT (WHITE) (RED) (YELLOW) AUDIO L OUT AUDIO R OUT VIDEO OUT B+ (YELLOW) ACC (RED) GROUND (BLACK) (OPTIONAL) R (RED) G (GREEN) B (BLUE) SYNC (BROWN) (OPTIONAL) (OPTIONAL) EXTERNAL REMOTE SE...

Page 9 - OPERATION

• Console When all the connections is finished,turn the unit on, switch the mode tonavigation mode, the unit will enter thefollowing interface automatically. Note: If you have set “Auto navigationwhen power on”, when you turn on theunit, it will skip Console interface andenter navigation interface a...

Page 11 - SOFTWARE OPERATION

1) When all the connections is finished, turn the unit on, switch the mode tonavigation mode, the unit will enter thefollowing interface automatically. Note: If you have set “Auto navigationwhen power on”, when you turn on theunit, it will skip Console interface andenter navigation interface automat...

Pyle PLNVB26 - Manual

Table of Contents:

Summary

Other Pyle Models