Pyle PLCD15MR - Manual - manualsarea.com

Page 2 - CONTENTS

2 Installation .....................................................................................................3 DIN Front-Mount....................................................................................................3 Installing the unit ................................................

Page 3 - TAKE OUT SCREW BEFORE INSTALL; Installing the unit; INSTALLATION

3 Notes: • The unit can be installed on the vehicle or the ships. • Choose the mounting location where the unit will not interfere with the normaldriving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sureit is all connected up properly and theu...

Page 4 - button to slide down the front

1. Dashboard2. Nut (5mm)3. Spring washer4. Screw (5x25mm)5. Screw6. Strap Be sure to use the strap to secure theback of the unit in place. The strap canbe bent by hand to the desired angle. 7. Plain washer Removing the unit 1. Before removing the unit, press the OPEN button to slide down the front p...

Page 5 - To Detach the Front Panel; To Reinstall the Front Panel; USING THE DETACHABLE FRONT PANEL

To Detach the Front Panel 1. Press the OPEN button, the front panel will slide down. 2. When the front panel slides down, press the bottom button of the frontpanel upward and pull it out from thepanel bracket. 3. For safekeeping, store the front panel in the supplied protective caseimmediately after...

Page 6 - WIRING CONNECTION

6 WIRING CONNECTION For 4 x 40W System GREEN GREEN/BLACK GREY GREY/BLACK VIOLET VIOLET/BLACK MAIN UNIT WHITE WHITE/BLACK FRONT Lch SPEAKER REAR Lch SPEAKER FRONT RchSPEAKER REAR RchSPEAKER Rch RED Lch WHITE (GREY) REAR RCA CABLE ANTENNA SOCKET RED YELLOW BLACK BLUE POWER ANTENNA GROUND (B–) MEMORY B...

Page 7 - GENERAL OPERATION; OPERATION

7 GENERAL OPERATION • ON/OFF Switch on the unit by pressing PWR button (9). When system is on, press PWR button (9) again to turn off the unit.Press PWR button (9) for more than 2 seconds, the button is operated toinitial volume control button. Whensystem power turns on, the volume isset to initial ...

Page 9 - RADIO OPERATION

RADIO OPERATION • BAND SELECTION At tuner mode, press BAND button (18) shortly to select the desired band.The reception band will change in thefollowing order: FM1 FM2 FM3 AM1/MW1 AM2/MW2 • STATION SELECTION Press button (16) or button (17)shortly to activate automatic seekfunction. Press for more t...

Page 10 - CD OPERATION

CD OPERATION • SELECT TRACKS Press button (16) or button (17) tomove to the previous track or thefollowing track. Track number showson display.Hold press button (16) or button (17) to fast reverse or fast forward. Discplay starts from when you release thebutton. • PAUSE PLAYING Press /MUTE button (3...

Page 11 - CD CHANGER OPERATION

11 CD CHANGER OPERATION • SELECT TRACKS Press button (16) or button (17) tomove to the previous track or thefollowing track. Track number showson display.Hold press button (16) or button(17) to fast reverse or fast forward. Discplay starts from when you release thebutton. • PAUSE PLAYING Press /MUTE...

Page 12 - FM; SPECIFICATION

12 GENERAL P ower Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 178 (D) x 50 (H) mm Tone Controls- Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 40 Watts Current Drain : 15 Ampere (max.) CD PLA YER Signal to Noise Ratio : Mo...

Page 13 - TROUBLE SHOOTING; Symptom

13 TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problemspersist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition switch is If the power supply is properly not on. connected to the ca...

Pyle PLCD15MR - Manual

Table of Contents:

Summary

Other Pyle Models