Premier Mounts PWM-503 - Manual

Page 2 - Contents

- 2 - o Safety & precautions o Mount diagrams o Parts List o Optional Adapters o Installing the mounting bracket o Installing the mount o Electrical o Securing the mount o Additional security Contents

Page 3 - Safety & Precautions

- 3 - The wall or ceiling structure must be capable of supporting at least five (5) times the weight of plasma display. If not, the wall or ceiling must be reinforced. Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to. Failure to do...

Page 4 - Mount Diagrams

- 4 - 16.000 5.460 1.250 3.250 16.000 4.500 1.750 18.500 1.125 8.000 8.000 5.000 1.000 4.500 5.460 2.865 3.500 e c A b 19.771 F d TILT BACK PLATE MOUNTING BRACKET PART#: PSB-TBP MATERIAL : 12 (GA) CRS COLOR : Black powder coat A . Lag bolt access slot. B . Mounting points (4.5") used on installa...

Page 5 - Parts List; TOOLS NEEDED

- 5 - o Phillips screwdriver o Drill gun o Soft material or a blanket o Pencil o ¼" drill bit o Level o Measuring tape o Wrench with a 1/2" socket o Stud finder o PCA-1 – 4.5" Ceiling adapter mates directly to the PSB-TBP tilt back plate o PSA-1 – Height adjustable ceiling adapter adjust...

Page 6 - Step 1; CAUTION; Step 2; Installing the mounting bracket

- 6 - Step 1 CAUTION : The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product. Invert the plasma display and set it on a flat and soft material such as (blankets, foam, cloth etc.) to prevent any damage to the pla...

Page 7 - Step 3; Installing the mounts; CENTER

- 7 - floor floor 16" Step 3 Select the area where the plasma will be installed and make sure it can support the weight standards (see warning on page 3). Locate the 16" wood stud centers behind the wall using a (commercially available) stud finder and mark the center of the studs when found...

Page 8 - Electrical

- 8 - floor floor To determine the desired viewing height, use the center slot opening in the wall mount as a center reference for the plasma television when mounted. Once the height is determined, use the bubble level to insure that the bracket is level. Next, using a pencil, mark the six (6) lag b...

Page 9 - Securing the mount; Additional security

- 9 - floor floor Securing the mount Step 5 Warning : The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury. Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing,...

Premier Mounts PWM-503 - Manual

Table of Contents:

Summary

Other Premier Mounts Models