Precor CW-113 - Manual - manualsarea.com

Page 3 - IMPOR; Important Safety Instructions; Obtaining Service

CW-113 Assembly and Maintenance Guide page 3 IMPOR T ANT SAFETY INSTRUCTIONS Important Safety Instructions Important Safety Instructions When using exercise equipment, basic precautionsshould always be taken, including the following: • Read all instructions before assembling theCW-113. These instruc...

Page 4 - Table of Contents

CW-113 Assembly and Maintenance Guide page 4 Table of Contents 1 2 Important Safety Instructions ................................................................................................... 3 Obtaining Service ......................................................................................

Page 5 - Preparations; Unpacking the Equipment; Required Tools; Installation Requirements

CW-113 Assembly and Maintenance Guide page 5 1 Preparations Preparations The CW-113 parts are inspected before shipment.Each unit contains several pieces that requireassembly. You will need to obtain adult assistanceduring the assembly process. Unpacking the Equipment When you open the box, carefull...

Page 6 - Fastener; Preparations, continued

CW-113 Assembly and Maintenance Guide page 6 ½ x 5¼-inch Buttonhead screw (E) 1 Fastener Qty Hardware Kit ³⁄₈ x ¾-inch Buttonhead screw (A) 12 ½-inch Washer (F) 2 ³⁄₈ -inch Washer (D) 2 ³⁄₈ -inch Split washer (B) 14 ³⁄₈ x 2¾-inch Buttonhead screw (C) 2 ½-inch Lock nut (G) 1 ⁵⁄₁₆ x 3-inch Buttonhead ...

Page 7 - Assembly Instructions

CW-113 Assembly and Maintenance Guide page 7 2 AssemblyInstructions Assembly Instructions Assembly of the CW-113 takes about 50 minutes tocomplete. If this is the first time you have assembledthis type of equipment, plan on allowing more time. Be careful to open boxes and assemble components inthe s...

Page 8 - Assemble the Unit

CW-113 Assembly and Maintenance Guide page 8 Assemble the Unit Assemble the Unit 1. Attach the Main Frame to the Stabilizer usingfour ¾-inch buttonhead screws (A)four ³⁄₈ -inch split washers (B) Wrench tighten. Note: Make sure the wheels on the Stabilizer are positioned as shown in the illustration....

Page 9 - Assemble the Unit, continued

CW-113 Assembly and Maintenance Guide page 9 Assemble the Unit, continued 5. Pull on the Adjustment Pin and slide the BackAdjustment through the Main Frame. Release theAdjustment Pin while it is aligned with the BackAdjustment middle hole. Note: Make sure the Springs slide onto the posts on the bott...

Page 11 - Assemble the Pads

CW-113 Assembly and Maintenance Guide page 11 Assemble the Pads Assemble the Pads 1. Attach the Back Pad to the Back Support usingfour 3-inch buttonhead screws (H)four 5 ⁄ 16 -inch split washer (J) four 5 ⁄ 16 -inch washers (K) Wrench tighten. 2. Attach the Thigh Pad to the Back Support usingsix 1¼-...

Page 12 - Clean the Pads and Assembly

CW-113 Assembly and Maintenance Guide page 12 Clean the Pads and Assembly Clean the Pads and Assembly To clean the pads moisten a clean, soft cloth in a mildsolution of soap and water and wipe the padsthoroughly. Dry the pads with a clean, dry cloth. Use the same procedure to clean the Main Frame an...

Page 13 - Limited Warranty

page 13 Limited Warranty Precor, Incorporated (PRECOR) will repair or replace any of the following components which aredefective as to materials or workmanship for products manufactured and sold after June 1, 1990: ICARIAN & STRETCH CENTER: Lifetime:Structural Steel FrameworkFive Years: Rotary B...

Page 16 - CW-113 Specifications

Precor is a registered trademark of Precor Incorporated.Specifications subject to change without notice.Copyright 2007 Precor Incorporated. www.precor.com Precor Incorporated20031 142nd Avenue NEP.O. Box 7202Woodinville, WA USA 98072-4002 NOTICE : Precor is widely recognized for its innovative, awar...

Precor CW-113 - Manual

Table of Contents:

Summary

Other Precor Models