Powermatic JTG-10Q - Manual

Page 2 - Warranty; More Information

2 This manual has been prepared for the owner and operators of a JTG-10Q Tenoning Jig. Its purpose, aside from machine operation, is to promote safety through the use of accepted correct operating and maintenance procedures. Completely read the safety and maintenance instructions before operating or...

Page 3 - Table of Contents

3 Table of Contents Warranty ........................................................................................................................................................ 2 Warnings ..............................................................................................................

Page 6 - Shipping Contents; Box Contents; Required Tools

6 Shipping Contents Open shipping carton and check that all parts are intact. Report any damage immediately to your distributor. Read the instruction manual thoroughly for assembly, alignment, maintenance and safety instructions. Model Number.............................................................

Page 7 - Assembly; Alignment

7 Assembly Refer to Figure 1. 1. Insert the handwheel assembly (F) into the clamp bracket (B) and secure with the lock handle (A) on the clamp bracket. 2. Attach the clamp bracket (B) to the back of the fence (G) using two M10 x 25 socket head cap screws (D) and M10 lock washers (E ). 3. Attach the ...

Page 9 - Operation

9 10. To prevent the fence from being pushed, or moved, into the blade, loosen the nut (N) on the setscrew and turn the setscrew clockwise until it bottoms out (Figure 6). Tighten down the nut. 11. For a final adjustment, loosen screw (P) holding the pointer and adjust pointer to the 1/8" positi...

Page 10 - Angle Tenons; Parts; Replacement Parts

10 6. If it is necessary to cut a tenon on the side of the workpiece that is against the fence, a wood spacer must be secured between the workpiece and the fence, as shown in Figure 9. This will keep the saw blade from hitting the fence. Note: There are four holes in the fence for mounting a wood bl...

Page 11 - Parts List

11 Parts List Index No. Part No. Description Size Qty 1 ............... JTG10-1 ................... Locking Lever....................................................... M6x22 ......................... 2 2 ............... TS-0680021 ............. Flat Washer .............................................

Page 12 - Exploded Vie