Plantronics 50-0230B-003 - Manual
Plantronics 50-0230B-003 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MOUNTING BRACKET
- Page 3 – I. PREPARATION OF VEHICLE INTERIOR; Remove A/C control head from cloth covered; FIGURE 1
- Page 4 – FIGURE 4
- Page 5 – FIGURE 7
- Page 6 – II. PREPARATION OF CONSOLE FOR INSTALLATION; Install front light fixture and secure using (3) three; III. INSTALLATION OF CONSOLE
- Page 7 – Do not overtighten screws. Use; Raise console into approximate position and; FIGURE
INSTALLATION INSTRUCTIONS
FOR
50-0230B-002
50-0230B-003
50-0230B-004
SUBURBAN
Overhead console with flip down TV
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions.
Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver 2. Powered screwdriver or drill with adapter
3. T-15 TORX bit driver 4. Razor knife or similar
5. T-45 TORX bit driver 6. 1/4” hex socket bit
7. Awl or similar tool 8. 3/32” Drill bit
9. Audiovox Series 645/655 Video Module
KEMCO
INSTALLATION INSTRUCTION # 44-0022B
May 26, 1999
Printed in the U.S.A.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 MATERIALS PROVIDED FOR INSTALLATION: ITEM Description QTY 1 SCREW, # 8 X 3/4" HWH 4 2 SCREW, # 6 X 1/2" PPH 4 3 SCREW, # 6 X 3/8" PPH 4 4 SCREW, # 8 X 2 1/2" PFH 3 5 SCREW, #8 X 1 1/4" PWH 2 6 MOUNTING BRACKET 1 7 CONSOLE 1 8 LIGHT 2 9 LIGHT TRIM 2 10 PLYWOOD, 3/8" X 6"...
3 I. PREPARATION OF VEHICLE INTERIOR 1. Remove the O.E.M. console mounted to inner roof of vehicle. Remove and discard (1) one screw from recess in front of console near rear view mirror. Disconnect wire harness and remove console from vehicle. Use care not to damage A/C control head. See Figure 1. ...
4 6. Carefully trim headliner from the dome light area toward the front of vehicle as shown. See figure 4. Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated. 7. Install the mounting bracket in the O.E.M. dome light area. Align...
