Pelco CM9740-UPG-8312 - Manual

C1547M (7/03) 3 UPGRADING SYSTEM 9740 SOFTWARE IN A SINGLE-NODE SYSTEM NOTE: Any external computer interface (such as an access control system, alarm system, fire system, building management/ control system, or VMX200) that is using the P protocol to communicate with a CM9740-CC1 running version 7.8...

4 C1547M (7/03) b. Remove the current System Manager program: (1) In the Windows taskbar, click the Start button. (2) Highlight Settings and then click Control Panel . (3) Double-click the Add/Remove Programs icon. (4) For a PC running Windows 95/98/NT: On the Install/Uninstall tab, click the System...

C1547M (7/03) 5 9. Upgrade the CC1 system software executable file, CM9740.EXE: a. Insert the System 9740 Operation Disk, Version 8.03.012, into the disk drive of the CC1. b. Copy the CM9740.EXE executable file from the 9740 directory on the Operation Disk to the C:\9740 directory of theCC1. At the ...

6 C1547M (7/03) UPGRADING SYSTEM 9740 SOFTWARE IN A MULTI-NODE SYSTEM NOTE: Any external computer interface (such as an access control system, alarm system, fire system, building management/ control system, or VMX200) that is using the P protocol to communicate with a CM9740-CC1 running version 7.8 ...

C1547M (7/03) 9 (b) Verify that the 9760NIU.EXE or NET9760.EXE file was renamed to 9760NIU.OLD or NET9760.OLD,respectively, by entering: dir/w (2) Insert the System 9760 Network Disk, version 8.03.012, into the disk drive of the NW1. (3) Copy the executable file, 9760NIU.EXE, from the Network Disk t...

10 C1547M (7/03) APPENDIX A. UPGRADING CM9740-MXB FIRMWARE CAUTION: Only qualified personnel observing electrostatic discharge (ESD) precautions should perform the proce- dure below. Always wear a grounding strap connected to an approved grounding source when working on or nearexposed electronic com...

12 C1547M (7/03) 5. Reinstall the video output card into slot 17 of the matrix bay (refer to Figure 2): a. Align the top and bottom edges of the card with the top and bottom card guides of the matrix bay. b. Slide the card toward the rear of the matrix bay until the card is seated firmly with the co...

C1547M (7/03) 13 APPENDIX B. CONNECTING AN ASCII COMMUNICATIONS DEVICE TO THE CM9740-CC1 As stated previously in this manual, version 8.03.012 of CM9740-CC1 software is not compatible with version 3.20 or earlier ofCM9760-DT/CM9760-DT4 software. If you wish to replace the existing DT/DT4 device (ext...

14 C1547M (7/03) CONNECTING AN ACD DB9 PORT TO A CM9740-CC1 RJ-45 PORT To connect an ACD DB9 port to a CM9740-CC1 RJ-45 port, refer to Figure 6 and do the following: 1. Connect the 9-pin side of the PV130 converter to a DB9 port of the ACD. 2. If necessary, connect a +12 VDC power supply to the PV13...

C1547M (7/03) 15 WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material orworkmanship for a period of one year after the date of shipment. Exceptions to this warranty areas noted below: • Five years on Pelco manufactured ca...