Paradyne SAM2000G-12 - Manual
Paradyne SAM2000G-12 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Install the SAM2000G in an IP DSLAM Chassis
- Page 3 – IP DSLAM Management
- Page 4 – ) for initial configuration instructions.
- Page 5 – Management User Guide:; Establish a Connection With Your IP DSLAM
- Page 6 – Establish a Connection With Your IP DSLAM; and the supported portions of MIB-II from the Internet; BANDWIDTH AND DISTANCE
- Page 7 – ADDITIONAL INFORMATION
- Page 8 – LED Indications
- Page 9 – Regulatory Compliance for Class A Equipment
SAM2000G-12
12-Port SHDSL Access Multiplexer
Also: SAM2000Q-12 (2B1Q) and SAM2000-12 (CAP)
1.0 SDSL ACCESS MODULE MODELS
SDSL access multiplexers are intended for use in Net to Net Technologies' IPD12000 and IPD4000
DSLAMs. Model types vary by the SDSL line code utilized.
1.1 SAM2000G-12
The SAM2000G-12 operates with Transmission Convergence/Pulse Amplitude Modulation (TC/PAM)
line code: a sixteen-level PAM technique which incorporates advanced Trellis code, precoding,
spectral shaping, equalization circuits and forward error correction. Otherwise known as G.SHDSL or
SHDSL.
1.2 SAM2000Q-12
The SAM2000Q-12 operates with Two Binary, One Quaternary (2B1Q) line code: a four-level PAM
technique which reduces the signaling rate to half of the bit rate.
1.3 SAM2000-12
The SAM2000G-12 operates with Carrierless Amplitude and Phase (CAP) modulation line code:
transmit and receive signals are modulated into two wide-frequency bands that can pass through a
filter without being attenuated.
Interface Module User Guide
N
OTE
Throughout this document, "SAM2000G" is utilized to indicate all three SDSL access multiplexer models; information
given applies to all three models except as individually stated or otherwise noted.
210-0000026 rev07
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2.0 INSTALLATION 2.1 Unpack and Inspect the SAM2000G If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877- 638-2638 (1-603-427-0600 for international customers) or [email protected] . 2.2 Install the SAM2000G in an IP DSLAM Chassis Net to Net Technol...
(pins 13-25 and 38-50 are not used) 3.0 SAM2000G DEFAULT CONFIGURATIONS No configuration is necessary for the SAM2000G to operate at default settings. 3.1 IP DSLAM Management 3.1.1 User Access 3.1.1.1 Network Management System (NMS) and Command Line Interface (CLI) 3.1.1.2 Simple Network Management ...
3.2 SAM2000G Port Parameters 4.0 SAM2000G MANAGEMENT Once your SAM2000G has been installed, bandwidth and other configurations are software selectable via your IP DSLAM's MUM. Dependent upon the MUM model installed, the SAM2000G may be configured via Command Line Interface (CLI), Simple Network Mana...
