Paradyne SAM2000G-12 - Manuals

Page 2 - Install the SAM2000G in an IP DSLAM Chassis

2.0 INSTALLATION 2.1 Unpack and Inspect the SAM2000G If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877- 638-2638 (1-603-427-0600 for international customers) or [email protected] . 2.2 Install the SAM2000G in an IP DSLAM Chassis Net to Net Technol...

Page 3 - IP DSLAM Management

(pins 13-25 and 38-50 are not used) 3.0 SAM2000G DEFAULT CONFIGURATIONS No configuration is necessary for the SAM2000G to operate at default settings. 3.1 IP DSLAM Management 3.1.1 User Access 3.1.1.1 Network Management System (NMS) and Command Line Interface (CLI) 3.1.1.2 Simple Network Management ...

Page 4 - ) for initial configuration instructions.

3.2 SAM2000G Port Parameters 4.0 SAM2000G MANAGEMENT Once your SAM2000G has been installed, bandwidth and other configurations are software selectable via your IP DSLAM's MUM. Dependent upon the MUM model installed, the SAM2000G may be configured via Command Line Interface (CLI), Simple Network Mana...

Page 5 - Management User Guide:; Establish a Connection With Your IP DSLAM

4.1 Via Command Line Interface (CLI) 4.1.1 Establish a Connection With Your IP DSLAM Establish a connection between your IP DSLAM and your PC, either directly (through the COM port on the MUM faceplate) or, if your DSLAM has been configured to allow inband management, across your local network. 4.1....

Page 6 - Establish a Connection With Your IP DSLAM; and the supported portions of MIB-II from the Internet; BANDWIDTH AND DISTANCE

4.2.4 Log In Log in with your assigned username and password. For SAM2000G configuration, you must log in as a superuser (general users have read only access). If your username and/or password are unknown, contact your System Administrator or Information Technology Manager for assistance. Once you h...

Page 7 - ADDITIONAL INFORMATION

The SAM2000G-12, SAM2000Q-12 and SAM2000-12 each have nine SHDSL bandwidth options; default is 272 kbps. Distance capabilities at each bandwidth vary, dependent upon the type of line code being utilized. Distances listed below assume the use of 26 American Wire Gauge (AWG) cable; connections made wi...

Page 8 - LED Indications

concurrently; SAM2000G configurations cannot be saved independently. Once your IP DSLAM has been configured as desired (including the SAM2000G), settings can be flash uploaded (to a local file) through a Trivial File Transfer Protocol (TFTP) tool with a GET command and the following information: 6.1...

Page 9 - Regulatory Compliance for Class A Equipment

(A pulsing LED blinks steadily at a rate of once per second. A flashing LED blinks at a more rapid, less constant rate.) 6.3 Regulatory Compliance for Class A Equipment The following regulatory compliance information applies to the SAM2000G-12, SAM2000Q-12 and/or SAM2000-12 as installed in Net to Ne...