Panasonic PT-TW381R - User Manual
Panasonic PT-TW381R Projector – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Remote control unit; LCD Projectors
- Page 4 – Standard setting-up position; Caution
- Page 5 – Projection distance; Screen aspect ratio 16:9; Calculatoin of the projection distance
- Page 6 – Installable angle; Vertical direction; The projector may be installed at a vertical angle of 30°.; Horizontal direction; The projector may be installed at a horizontal angle of 15°.
- Page 7 – List of compatible signals
- Page 8 – Note
Specifications
Main unit
Power supply
AC100-240 V, 50 Hz/60 Hz
Power consumption
300 W
6W when Standby mode set to Normal, 0.5W when Standby mode set to Eco*
1
* Operating Temperature: 25°C (77°F), Altitude: 700m (2,297 ft), IEC62087: 2008 Broadcast contents,
Picture mode: Dynamic
BTU value
Max 1,024BTU
LCD panel
Panel size
15.0 mm (0.59 inches) diagonal (16:10 aspect ratio)
Display method
Translucent screen LCD panel 3 panels, 3 primary color system
Pixels
1,024,000 (1280 pixels x 800 dots) x 3 panels
Colors
Full color (16,777,216 colors)
Lens
Fixed focus
Manual focus: F = 1.8, f = 6.08 mm
Throw ratio
0.46:1
Light source
230 W UHM lamp
Lamp replacement cycle
Normal: 10,000hrs / Eco: 20,000hrs / Quiet: 10,000hrs
Light output*
2
3,300 lm
(When [PICTURE MODE] is set to [DYNAMIC], [LAMP POWER] is set to [NORMAL], [AUTO POWER SAVE] is set to [OFF],
and [DAYLIGHT VIEW] is set to [OFF])
Filter replacement cycle*
3
Normal: 5,000hrs / Eco: 6,000hrs / Quiet: 10,000hrs
Center-to-corner uniformity*
2
85%
Resolution
1280 x 800 pixels (Input signals that exceed this resolution will be converted to 1280 x 800 pixels.)
Contrast ratio*
2
20,000:1
(When [PICTURE MODE] is set to [DYNAMIC], [LAMP POWER] is set to [NORMAL], [IRIS] is set to [ON],
[AUTO POWER SAVE] is set to [OFF], and [DAYLIGHT VIEW] is set to [OFF])
Screen size
1.27-2.54 m (50-100 inches) diagonally, 16:10 aspect ratio
Installation
[FRONT/DESK], [FRONT/CEILING], [REAR/DESK], [REAR/CEILING]
Keystone correction range
Vertical:±15 ° (Auto, Manual), Horizontal:±15 ° (Manual)
Compatible signals
Video signal
Horizontal : 15.73 kHz, Vertical : 59.94 Hz
Horizontal : 15.63 kHz, Vertical : 50.00 Hz
Y/C signal
Horizontal : 15.73 kHz, Vertical : 59.94 Hz
Horizontal : 15.63 kHz, Vertical : 50.00 Hz
RGB signal
Displayable resolution: 640 x 400 to 1920 x 1200
Dot clock frequency: 162 MHz or less
YC
B
C
R
/YP
B
P
R
signal
Displayable resolution: 480i/576i to 1920 x 1080
Dot clock frequency: 148.5 MHz or less
HDMI signal
Displayable resolution for movie-based signals: 480i/576i* to 1920 x 1080
Displayable resolution for still image signals: 640 x 400 to 1920 x 1200 (non-interlaced)
*Pixel-Repetition signal (dot clock frequency 27.0 MHz) only
Dot clock frequency: 25 MHz to 162 MHz
Terminals
COMPUTER 1 IN
1 (High-density D-sub 15 pin female)
R, G, B
0.7 V [p-p] 75 Ω
HD/SYNC TTL high impedance, automatic positive/negative polarity compatible
VD TTL high impedance, automatic positive/negative polarity compatible
(HD/SYNC and VD do not support 3 value SYNC.)
Y, P
B
(C
B
), P
R
(C
R
)
Y: 1.0 V [p-p] including synchronization signal, P
B
(C
B
), P
R
(C
R
): 0.7 V [p-p] 75 Ω
Y/C signal
Y: 1.0 V [p-p] C: 0.286 V [p-p] 75 Ω S1 signal compatible
COMPUTER 2 IN/
COMPUTER 1 OUT
1 (High-density D-sub 15 pin female)
R, G, B
0.7 V [p-p] 75 Ω
HD/SYNC TTL high impedance, automatic positive/negative polarity compatible
VD TTL high impedance, automatic positive/negative polarity compatible
(HD/SYNC and VD do not support 3 value SYNC.)
Y, P
B
(C
B
), P
R
(C
R
)
Y: 1.0 V [p-p] including synchronization signal, P
B
(C
B
), P
R
(C
R
): 0.7 V [p-p] 75 Ω
VIDEO IN
1 (Pin jack 1.0 V [p-p] 75 Ω
HDMI IN
2 (HDMI 19 pin, HDCP and Deep color compatible)
Audio signal
Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
AUDIO IN 1
1 (M3 stereo mini jack, 0.5 V [rms], input impedance 22 kΩ and more)
AUDIO IN 2
1 (Pin jack x 2 (L-R), 0.5 V [rms], input impedance 22 kΩ and more)
AUDIO OUT
1 (M3 stereo mini jack, stereo monitor output compatible,
0 V [rms] to 2.0 V [rms] variable, output impedance 2.2 kΩ and less)
PT-TW381R
LCD Projectors
As of A pril 2 02 0
1 / 8
TW381RG_STR_01_30/04/2020
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Terminals USB USB connector (type A x 1)Memory Viewer / Wireless module (Model No.: AJ-WM50 / ET-WML100) compatible / power supply (DC 5 V, maximum 2 A) SERIAL IN 1 (D-sub 9 pin, RS-232C compliant, for computer control use) LAN 1 (for RJ-45 network connection, PJLink (Class 2) compatible, 10Base-T/1...
Standard setting-up position Screen ø48.6 [1-29/32] SH Screen L 68.5 [2-11/16] 66 [2-19/32] 132 [5-3/16] 66 [2-19/32] 71 [2-25/32] 71 [2-25/32] 142 [5-19/32] 370–450 [14-9/16–17-23/32] Adjustable in 20 [25/32-inch] step. L L H H SH 197 [7-3/4] 132 [5-3/16] Upper edge of projected image Upper edge of...
Projection distance A ±5% error in listed projection distances may occur.When [SCREEN ADJUSTMENT] is used, distance is corrected to become smaller than the specified image size. Screen aspect ratio 16:10 Unit: meters [feet] Projection size Projection distance Height from the edge of screen to center...
