Optimus PRO SWS-502 - Manual

Optimus PRO SWS-502

Optimus PRO SWS-502 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – CONNECTIONS; Preparing the Wires; Connecting the Wires
  • Page 3 – Note: You can use the
  • Page 4 – SPECIFICATIONS; RADIO SHACK LIMITED WARRANTY
Loading the manual

R

Cat. No. 40-4052

©

1995 Tandy Corporation.

All Rights Reserved.

Optimus and Radio Shack are registered trademarks used by Tandy Corporation.

PRO SWS-502 Satellite Subwoofer Speaker System

Your Optimus PRO SWS-502 Satellite
Subwoofer Speaker System is designed
to add the dramatic realism of solid bass
(below 200 Hz) to your sound system.
While the satellite speakers reproduce the
high, midrange, and upper-bass frequen-
cies, the subwoofer’s bass reflex design
provides a clean response in the crucial
bottom octave of the audible range. This
results in heightened presence and clarity
for the entire audio range.

The subwoofer’s low-bass sounds are
produced by a down-firing 10-inch driver
with a 1

1

/

2

-inch dual-voice coil. Each sat-

ellite speaker has a 3

1

/

2

-inch woofer with

a

1

/

2

-inch liquid cooled soft-dome tweeter

in a separate enclosure that swivels so
you can adjust it for the best stereo imag-
ing.

SPEAKER PLACEMENT

Choosing a Location for the
Satellites

Location and position are vital for the best
sound performance of your satellite
speakers. For the best stereo image, the
distance between the speakers should be
about the same as the distance from the
main listening area to a point halfway be-
tween the speakers.

If you place the speakers too far apart,
you might hear a “hole” in the center of the
sound. Compensate for this by angling the
speakers slightly in toward the listening
area.

If you place the speakers too close togeth-
er, you will cancel out the stereo image.
Compensate for this by angling the speak-
ers slightly away from the listening area.

40-4052.fm Page 1 Wednesday, August 11, 1999 9:34 AM

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CONNECTIONS; Preparing the Wires; Connecting the Wires

. 2 Tables or shelves near a corner are ideallocations — for example, a decorator shelfattached to a wooden wall (or otheracoustically hard surface). If possible,place the front edge of the speakers flushwith the front edge of the shelf. Avoid floorlocations, since floor coverings can ab-sorb many o...

Page 3 - Note: You can use the

3 To help you make the proper connec-tions, one side of each pair of speakerwire conductors is marked with a stripe orgroove, normally considered the positive(+) polarity wire. Note: The insulation in some speakerwires is clear, and the separate conduc-tors are brass and silver. Use the brasswire as...

Page 4 - SPECIFICATIONS; RADIO SHACK LIMITED WARRANTY

RADIO SHACK A Division of Tandy Corporation Fort Worth, Texas 76102 2A5 Printed in Korea SPECIFICATIONS Frequency Response .................................................................... (Subwoofer) 30-220 Hz (Satellite) 155-20,000 Hz Power Handling ................................................

Other Optimus Models

All Optimus Other