OmniMount PMD2 - Manual
OmniMount PMD2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Model; Part; Step 5
- Page 3 – Step 1
- Page 4 – Wall Mount; Step 2
8
Thank you for purchasing an OmniMount product.
Specifications are subject to change without prior notice.
Every effort has been made to provide accurate and error-free assembly and installation.
OmniMount Systems disclaims liability for any difficulties arising from the interpretation
of information contained in these instructions. If OmniMount products are used for pur-
poses other than their original intent, OmniMount, its distributors and retailers shall not
be held responsible or liable for injuries or property damage, direct, indirect, or conse-
quential, which may arise from the inability to use this product safely, properly, and in the
manner for which it has been designed and manufactured. Warranty does not apply to
products which have been lost, damaged by misuse, abuse, or accident.
OmniMount Systems, Inc.
8201 South 48th Street • Phoenix, AZ 85044-5355
1-800-MOUNT-IT • www.omnimount.com
P/N 1002082—Rev. D 9/2004
Universal Mounting Grid
Superior Mounting Flexibility
Adjustable Ceiling Pipe Drop
Installation Instructions
PMD.5 — PMD1— PMD2:
Universal Projector Mounts
IMPORTANT:
To utilize the
PMD projector mount, the projector must have
mounting lands (threaded inserts) on the base. Contact OmniMount if you have any
questions regarding the proper installation of this projector mount system.
Questions? 1-800-MOUNT IT
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Model s : PMD.5 — PMD1 — PMD2 Part Description Qty. Mount Assembly Hard-ware A Top Projector Plate 1 B Bottom Projector Plate 1 C Pipe Drop Assembly 1 D Plastic Cover 1 E Ceiling Plate 1 Bag F Hex Screw: ¼”-20 X ¼” 1 (d) G Screw: ¼”-20 X 3/8” 2 (c) H Hex Screw: ¼”-X 5/8” 4 (d) I Hex Screw: ¼”-X ½”...
6 Repeat this procedure for the remaining threaded inserts. (Fig. 10) Note: A 1” plastic spacer (3) is included for projectors with uneven mounting surfaces. Trim the plastic spacer to the required length, and install on appropriate mounting screw. Fig. 8 Fig. 9 Fig. 10 Once all mounting screws have...
4 Flush Ceiling Mount For installations with low ceilings, the flush ceiling mount should be used. Note: cable management is not available with the flush mount. Proceed to step 3. Wall Mount With the addition of the OmniMount PMD-WM wall mount (sold separately); the PMD can be mounted to a wall inst...
