Omega OI64Z - User Manual - manualsarea.com

Page 3 - SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS We have included this section for your safety. Please read this information carefully before using your hob. WARNING: · It is hazardous for anyone other than authorised service personal, to carry out servicing or repairs which involve the removal of covers. · To avoid the risk of...

Page 4 - Safety when cleaning:

Human safety: · During operation the hob surface can get hot, small children must be kept away from the appliance. · Users with implanted pacemakers should keep their upper body at least 30cm from induction cooking zones that are switched on. · This appliance is not intended for use by persons (incl...

Page 5 - DESCRIPTION OF THE APPLIANCE; for future reference.; Cooking Surface for 4 heater:

DESCRIPTION OF THE APPLIANCE Dear Customer, Please read the instructions in this user guide before using the hob and keep it for future reference. Cooking Surface for 4 heater: 4 Cooking Surface for 3 heater: Induction heating element Control panel Control panel Induction heating element

Page 7 - OPERATION OF THE APPLIANCE; buzzer; heater selection

OPERATION OF THE APPLIANCE Use the induction cooking zones with suitable cookware. After mains voltage is applied, all displays are come on for a moment. When this time is over, the hob is in the stand-by mode and it is ready for operation. The hob is controlled with electronic sensors which are ope...

Page 9 - Heat setting

Safety switch off function: Every cooking zone will be switched off after a defined maximum operation time if the heat setting is not modified. Every change in the cooking zone puts back the maximum operation time to the initial value of the operating time limitation. The maximum operation time depe...

Page 12 - HINTS AND TIPS; Cookware; CORRECT

HINTS AND TIPS Cookware · Use thick, flat, smooth bottomed cookwares that are the same diameter as the element. This will help reduce cooking times. · Cookware made of steel, enamelled steel, cast iron and stainless steel (if appropriately abelled by the manufacturer) will give you the best results....

Page 13 - Examples of cooking applications; The information given in the following table is for guidance only.; Cleaning tips; when they spill, before the glass has cooled down.

Examples of cooking applications The information given in the following table is for guidance only. Cleaning tips · Do not use abrasive pads, corrosive cleaners, aerosol cleaners or sharp objects to clean the surfaces of the hob. · To remove burnt food, soak it off with a damp cloth and washing-up l...

Page 14 - INSTALLATION OF THE APPLIANCE; This appliance must be earthed.; Installation safety; Any overhanging surface should be at least 65cm above the hob.; Fitting the hob into a work surface; Induction hob may be built in the 25 to 40 mm thick worktops.; 0cm induction hob

INSTALLATION OF THE APPLIANCE WARNING: The electrical connection of this hob should be carried out by a qualified electrician, according to the instructions in this guide and in compliance with the current regulations. In the event of any damage that occurs as a result of improper connection or inst...

Page 15 - Screw the 4 worktop mounting brackets on the side walls of product.; worktop; have an opening of no less than 5 mm.

Screw the 4 worktop mounting brackets on the side walls of product. worktop mounting bracket · Secure the hob in place by putting it into cutout on the work surface. · Before inserting the oven, it is necessary to remove the rear kitchen element panel in the area of the oven opening, in order to sup...

Page 16 - Making an electrical connection; Before making a connection, check that:

Making an electrical connection Before making a connection, check that: · The mains voltage is the same as that quoted on the rating plate which is situated at the back of your hob. · The circuit can support the appliance load (see the rating plate). · The power supply has an earth connection, which...

Page 17 - Electrical connection diagram; the connection diagram shown on the bottom of your appliance.

Electrical connection diagram For the induction hob, the cable must be H05VV-F 3X2,5 mm²/60227 IEC 53 ••. You will find the connection diagram shown on the bottom of your appliance. 16 * This appliance must be earthed.* For this connetion a power lead of wire type H05V V -F should be used. 3x2,5 mm3...

Omega OI64Z - User Manual

Table of Contents:

Summary

Other Omega Hobs Models