Omega CIO-DAC08 - Manual

. Figure 3-3. Simultaneous Update Jumper 3.5 Analog Output Range Switches The analog output voltage range of each channel can be set with a set of five gangedDIP switches. The switch blocks are located on the board below the calibrationpotentiometers. The switch blocks are labeled 0 to 15 (0 to 7 on...

To set a channel to a particular range, read the switch positions as UP or DN (down)from left to right in the row beside the range you desire. For example, the ±5V range is: UP>DN>DN>UP>DN. 3.6 Installing the CIO-DAC## in the Computer Turn the power off. Remove the cover of your computer...

3.9 Signal Connection The analog outputs of the CIO-DAC## are two-wire hookups. A signal, labeledD/A # OUT on the connector diagram below, and a Low Level Ground (LLGND).The low level ground is an analog ground and is the ground reference which shouldbe used for all analog hookups. Possible analog o...

3.10 Connector Diagram The CIO-DAC## connector is a 37-pin D-type connector accessible from the rear ofthe PC through the expansion backplate. The connector accepts female 37-pin D type connectors, such as those on theC37FF-2, 2 foot cable with connectors. If frequent changes to signal connections o...

4 REGISTER ARCHITECTURE The CIO-DAC## is a simple board to understand. All control and data isread/written with simple I/O read and write commands. No interrupt or DMAcontrol software is required. Thus, the board's functions are easy to control directlyfrom BASIC, C or PASCAL. 4.1 Control & Data...

4.2 Output Transfer Functions To program a DAC, you must select the output you desire in volts, then apply atransfer function to that value. The transfer function for code = output is: The UNIPOLAR transfer function of the DAC is: FSV / 4096 * CODE = OutV or CODE = OutV / FSV * 4096 For Example:If t...

5 SPECIFICATIONS POWER CONSUMPTION CIO-DAC16 +5V supply 435 mA typical, 525 mA max +12V supply 140 mA typical, 180 mA max − 12V supply 80 mA typical, 105 mA max CIO-DAC08 +5V supply 435 mA typical, 525 mA max +12V supply 75 mA typical, 98 mA max − 12V supply 52 mA typical, 68 mA max ANALOG OUTPUT D/...

Update DACs individually orsimultaneously (jumper-selectable bypairs)DAC output state on power up and resetundefined ENVIRONMENTAL Operating temperature range 0 to 70°C Storage temperature range − 40 to 100°C Humidity 0 to 90% non-condensing 13

EC Declaration of Conformity 8 Channel analog output board CIO-DAC08 16 Channel analog output board CIO-DAC16 Description Part Number to which this declaration relates, meets the essential requirements, is in conformitywith, and CE marking has been applied according to the relevant EC Directives lis...