Nutone 770F - Manual
Nutone 770F – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – FIGURE 2
- Page 4 – PLANNING; INSTALLATION IN EXISTING CONSTRUCTION; One Year Limited Warranty
- Page 5 – FIGURE 1; CONSIGNES DE SECURITE IMPORTANTES; INSTRUCTIONS D’INSTALLATION; POUR DE MEILLEUR RESULTATS; • CONVIENT A UNE UTILISATION AU-DESSUS D’UNE
- Page 7 – COMPLETER L’INSTALLATION; FIGURE 6
- Page 8 – PREPARATION; INSTALLATION DANS UNE CONSTRUCTION EXISTANTE; Garantie limitée d’un an
- Page 9 – PARA LOGRAR MEJORES RESULTADOS; FIGURA 1; INSTRUCCIONES DE INSTALACIÓN; ADVERTENCIA: PARA REDUCIR EL RIESGO DE
- Page 10 – MONTAJE DEL BASTIDOR; INSTALACIÓN DE LOS CONDUCTOS; FIGURA 2
- Page 12 – INSTALLACIÓN EN UN EDIFICIO YA EXISTENTE; Garantía Limitada de un Año
- Page 13 – PARTS LIST
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Bathroom Exhaust
Fan/Fluorescent
Light Combination
MODEL: 770F
FOR BEST RESULTS
When installing the Exhaust Fan/Light in a new
construction site, install housing during the rough-in
construction of the building. The blower unit and grille should
be installed after the finished ceiling is in place.
To install the Exhaust Fan/Light in an existing finished
building see instructions page 4.
FIGURE 1
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE.
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have questions, contact the
manufacturer.
B. Before servicing or cleaning unit, switch power off at
service panel and lock service panel to prevent power from
being switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION:
For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
INSTALLATION INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction.
B. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow the
heating equipment manufacturer's guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
D. Ducted fans must always be vented to the outdoors.
E. If this unit is to be installed over a tub or shower, it must be
marked as appropriate for the application.
F. NEVER place a switch where it can be reached from a tub
or shower.
•
The exhaust fan consists of the housing, power unit/blower
assembly (motor, wheel, mounting plate,) grille/lens
assembly, reflector/lamp plug assembly (lamps not
furnished) and duct collar.
•
WARNING: To reduce the risk of fire or electric shock,
do not use this fan with any solid-state speed control
device.
•
Not for use in kitchens.
•
For installation in sloped ceilings up to 12/12 pitch.
•
Ductwork must point up.
DUCT COLLAR
HOUSING
SLOTS
TABS
POWER UNIT/
BLOWER
ASSEMBLY
GRILLE
REFLECTOR
LENS
• SUITABLE FOR USE OVER A TUB OR
SHOWER WHEN INSTALLED IN A G.F.C.I.
PROTECTED BRANCH CIRCUIT .
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PLANNING DUCTWORK AND WIRING DUCTWORK 1. Use 4" round duct.2. Plan to run duct from the fan's discharge opening to the outside. For best fan performance, make duct run as shortas possible and use minimum number of elbows. 3. Use optional NuTone ducting accessories as needed (refer to NuTone's ca...
Product specifications subject to change without notice. 4820 Red Bank Road, Cincinnati, Ohio 45227 Printed in U.S.A., Rev. 5/02, Part No. 88731 PLANNING Installing a bathroom exhaust fan-light in a finished house requires at least a small accessible area (attic or crawl space)above the planned inst...
INSTRUCTIONS D'INSTALLATION LIRE ET CONSERVER CES INSTRUCTIONS Ventilateur d’evacuationavec eclairage fluorescentpour la salle de bain Modele: 770F FIGURE 1 CONSIGNES DE SECURITE IMPORTANTES ADVERTISSEMENT: AFIN DE REDUIRE LES RISQUES D’INCENDIE. CHOC ELECTRIQUE, OU DE TOUTE BLESSURESOBSERVEZ LES CO...
