Nostalgia KRS-2000 Series - Manual

3 Introduction • To ensure that your KEGORATOR™ works to the maximum efficiency it was designed for, keep it in a location where there is proper air circulation and electrical outlets. • Choose a location where the KEGORATOR ™ will be away from heat and will not be exposed to direct sunlight. • This...

4 CO2 Bottle Regulator Hose #2 Connects Dispenser Assembly to Beer Tap CO2 Bottle Beer Tap Handle Hose #1 Connecting Beer Tap to Regulator & CO2 Bottle Part Connects to Keg Large Butterfly Nut Secures Hose to Beer Tap Parts & Assembly Read assembly instructions carefully to ensure that you u...

5 Regulator The regulator works the Co2 Tank Valve and measures PSI (pounds per square inch), as well as the volume of the Co2 gas in the Cylinder. Output Pressure Gauge (0-60 PSI) for measuring PSI of CO2 in tank. Tank Pressure Gauge (0-3000 PSI) for measuring PSI of CO2 outflow from Tank to Keg. S...

6 There are three different possible backflow stoppers. STEP 4 Connect the CO2 line from the regulator to the coupler. STEP 1 High pressure washer installed into CO2 regulator (may already be installed). STEP 2 Attach regulator to CO2 tank connector. STEP 3 The CO2 rubber directional washer goes int...

7 Installation, contin. STEP 6 After the backflow stopper has been inserted, there is a washer that should be placed on top of the coupler. STEP 7 After the tap tower has been placed on the refrigerator and the hose line feeds through the bottom, attach the wing nut to the coupler. O-rings on the CO...

8 Installing the Casters Follow the steps below to install the casters. 1. Empty the inside of the cabinet completely and lay the KEGORATOR™ down on it’s side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches. 2. Insert the casters into t...

9 Black pull handle Connect to theBeer Line Tube Connect toCO2 Gas Line Tube Keg Coupler T U R N C L OC KWI S E Beer Keg Neck Keg Support Beer Keg Lift Upright Tapping the Beer Keg (Single-Valve Type Barrel) Follow these steps below to tap the beer keg.1. Make sure the black pull handle of the coupl...

10 Operating Your KEGORATOR™ Dispensing Beer Follow the steps below to dispense beer. 1. Make sure that the KEGORATOR™ is plugged in properly to a 120V, 60Hz, 15Amps grounded AC outlet. 2. Place the drip tray under the beer faucet to avoid messes from excess beer. 3. Open the beer faucet by pulling ...

11 RETURNS & WARRANTY INFORMATION SHOULD YOUR UNIT NOT WORK OR IS DAMAGED WHEN YOU FIRST TAKE IT OUT OF THE BOX PLEASE RETURN IT TO THE PLACE OF PURCHASE IMMEDIATELY. Should you have any questions, please contact us via email or at the customer service number listed below between the hours of 8:...