Page 2 - KEGORATORTM; INSTRUCTION MANUAL; FOR HOUSEHOLD USE ONLY
KEGORATOR™ KRS-2000 SERIES INSTRUCTION MANUAL FOR HOUSEHOLD USE ONLY READ THESE INSTRUCTIONS BEFORE USING THIS UNIT! SAVE THESE INSTRUCTIONS!
Page 3 - Safety Precautions
1 Safety Precautions Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this operation manual. 2. This appliance must be properly i...
Page 4 - SAVE THESE INSTRUCTIONS; Risk of child entrapment! Before throwing away your old
2 Important Safety Precautions of CO2(Carbon Dioxide) Gas 1. CO2 gas can be dangerous! CO2 cylinders contain high-pressure compressed gas, which can be hazardous if not handled properly. Make sure you read and understand all the procedures for the CO2 cylinders before installation. 2. Always connect...
Page 5 - Introduction; Compatible Keg Types
3 Introduction • To ensure that your KEGORATOR™ works to the maximum efficiency it was designed for, keep it in a location where there is proper air circulation and electrical outlets. • Choose a location where the KEGORATOR ™ will be away from heat and will not be exposed to direct sunlight. • This...
Page 6 - Accessories List
4 CO2 Bottle Regulator Hose #2 Connects Dispenser Assembly to Beer Tap CO2 Bottle Beer Tap Handle Hose #1 Connecting Beer Tap to Regulator & CO2 Bottle Part Connects to Keg Large Butterfly Nut Secures Hose to Beer Tap Parts & Assembly Read assembly instructions carefully to ensure that you u...
Page 7 - Regulator
5 Regulator The regulator works the Co2 Tank Valve and measures PSI (pounds per square inch), as well as the volume of the Co2 gas in the Cylinder. Output Pressure Gauge (0-60 PSI) for measuring PSI of CO2 in tank. Tank Pressure Gauge (0-3000 PSI) for measuring PSI of CO2 outflow from Tank to Keg. S...
Page 8 - Installing the CO2 Regulator and the CO2 Cylinder
6 There are three different possible backflow stoppers. STEP 4 Connect the CO2 line from the regulator to the coupler. STEP 1 High pressure washer installed into CO2 regulator (may already be installed). STEP 2 Attach regulator to CO2 tank connector. STEP 3 The CO2 rubber directional washer goes int...
Page 9 - Washers
7 Installation, contin. STEP 6 After the backflow stopper has been inserted, there is a washer that should be placed on top of the coupler. STEP 7 After the tap tower has been placed on the refrigerator and the hose line feeds through the bottom, attach the wing nut to the coupler. O-rings on the CO...
Page 10 - Installing the Casters; Installing the Beer Tap; Installing the Guardrail
8 Installing the Casters Follow the steps below to install the casters. 1. Empty the inside of the cabinet completely and lay the KEGORATOR™ down on it’s side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches. 2. Insert the casters into t...
Page 11 - CO2 can be dangerous! CO2 cylinders contain
9 Black pull handle Connect to theBeer Line Tube Connect toCO2 Gas Line Tube Keg Coupler T U R N C L OC KWI S E Beer Keg Neck Keg Support Beer Keg Lift Upright Tapping the Beer Keg (Single-Valve Type Barrel) Follow these steps below to tap the beer keg.1. Make sure the black pull handle of the coupl...
Page 12 - Operating Your KEGORATORTM; Cleaning & Maintenance
10 Operating Your KEGORATOR™ Dispensing Beer Follow the steps below to dispense beer. 1. Make sure that the KEGORATOR™ is plugged in properly to a 120V, 60Hz, 15Amps grounded AC outlet. 2. Place the drip tray under the beer faucet to avoid messes from excess beer. 3. Open the beer faucet by pulling ...
Page 13 - RETURNS & WARRANTY INFORMATION; Customer Service
11 RETURNS & WARRANTY INFORMATION SHOULD YOUR UNIT NOT WORK OR IS DAMAGED WHEN YOU FIRST TAKE IT OUT OF THE BOX PLEASE RETURN IT TO THE PLACE OF PURCHASE IMMEDIATELY. Should you have any questions, please contact us via email or at the customer service number listed below between the hours of 8:...