NEC LA-1422JMW - Manual
NEC LA-1422JMW – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; Canadian Department of Communications Compliance Statement; FCC Information
- Page 3 – Contents; Your new NEC Technologies MultiSync
- Page 4 – Quick Start; To attach the MultiSync
- Page 6 – OSM; Brightness and Contrast; Controls
- Page 8 – Recommended Use
- Page 10 – Specifications
- Page 11 – Features
- Page 12 – Troubleshooting
- Page 13 – References; INFORMATION
- Page 14 – Limited Warranty
- Page 15 – NEC LCD Series; DECLARATION OF CONFORMITY
MultiSync
®
LCD
400V
™
User’s Manual
Contents
1
Quick Start
2-3
Controls 4-5
Recommended Use 6-7
Specifications
8
Features
9
Troubleshooting
10
References
11
Limited Warranty
12
MultiSync
®
LCD
400V
™
User’s Manual
78133331
9/25/98, 12:46 PM
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. ALSO, DO NOT USE THIS UNIT'S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGSCAN BE FULLY INSERTED.REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE. REFER SER...
MultiSync LCD 400V Contents 1 Your new NEC Technologies MultiSync ® LCD monitor box* should contain the following: • MultiSync LCD 400V ™ monitor, LA-1422JMW, with tilt/swivel base • Power Cord• Video Signal Cable• User’s Manual• Registration Card * Remember to save your original box and packing mat...
Quick Start To attach the MultiSync ® LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer.2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable to the connector of the display card in your system (Figure A.1) . Tighten all screws. For ...