NEC 456-01721-000 - Manual

-3- Before Unpacking the Cabinet 1. Check the packing list to verify that you have received the correct shipment. 2. Verify that the Tip-N-Tell and Shockwatch handling indicators on the outside of the shipping container have not been activated. C A U T I O N ! If you received the wrong shipment or a...

-6- If the corridor and door dimensions are large enough to accommodate the unpacked cabinet still tied to its pallet, use a pallet jack to move it from the delivery site to the installation site, as described in “Moving the Cabinet to the Installation Site” on page 6 . If the corridor and door dime...

-7- present, see the section “Stabilizing the Systems” on page 19 for stabilization guidelines. When shipped, the system cabinet is tied to the pallet beneath it. The pallet has a clearance for a pallet jack to move the unit. When moving a system cabinet, follow these guidelines: 1. Verify that the ...

-8- Tools Needed to Unpack the Cabinet Use the following tools to unpack the cabinet: • Metal shears to cut pallet straps • Pair of scissors or utility knife • One 3/8-inch drive ratchet with a 9/16-inch socket Removing the Packing Materials W A R N I N G ! To avoid personal injury or damage to the ...

-15- Figure 11. Sliding Back the Wooden Restraint Blocks 14. Move the lever bar to the opposite side of the cabinet. Repeat the process of tilting the cabinet and sliding back the two wooden restraint blocks on the opposite side of the cabinet. Removing the Cabinet from the Pallet 1. Position the pa...

-17- Figure 13. Moving the Cabinet Down the Pallet Ramp 3. Check the cabinet and systems for damage, as the next section describes. Checking the Cabinet and Systems Check the cabinet, systems, and optional components for damage: 1. Open the rear door of the cabinet. From the bottom of the cabinet, r...

-19- Stabilizing the Systems If temperature and humidity changes have been extreme during transit, the cabinet and systems might develop condensation. Therefore, before you install and power on the systems, you must inspect them and the cabinet for condensation and, if necessary, stabilize the syste...

-20- 4. Continue the installation, and continue to inspect for signs of condensation. If condensation appears, allow additional stabilization periods until there are no signs of condensation. C A U T I O N ! Before you power on the systems, verify that the installation site environment meets the req...

-21- To gain access to the documents on the World Wide Web, point your browser to: http://support.necam.com/servers/ Getting Help If you have a technical question about Express5800/320 Fc hardware or software, try these online resources first: • Online support from NEC Technical Support. You can fin...