MyGenie 10001328 - User Manual

2.Product Composition ► Charging Stand Assembly ► Remote Control � - - - Indicator Light - - Power Adapter � - - - - Power Adapter Slots -+-+----11----- Screen Forward---+---1--:==:::::;--� Setting time / Schedule-------H-+--4,!;!V Left-----11--1-+;n Right Stop/Start ------ir---r------;r;7'1------l....

2.Product Composition ► Dust Box Primary Filter-- - - � ��:"'51 - - Efficient Bracket Lower Cover Filter Sponge -- Dust Box Upper Cover ► Water Permeable Rag Assembly Water Rag - - - �- ====--� 7

2.Product Composition 2.2 Technical Parameters Master Working Voltage: 1 0.89 V = Charging Stand Rated Input Voltage: 19 V = Battery and Specifications Adapter : Output parameter 100-240V ~50/60HZ Input parameter 19VDC/0.6A 8 Power Rating: 20W Rated output current: 0.6A Lithium Battery 2600mAh

3.Product Composition 3.1 Considerations Please refer to the following guidelines to check the cleaning area before the turning on the unit for a more efficient clean. 0 Power lines and other debris scattered on the ground may trip up and must be removed before . • _J -- • • \.a� ,_, � - A gap of le...

3.Product Composition 3.2 Rapid Operation Charging Preparation D Connect the adapter to the charging stand . Place the charging stand flat against the wall. Do not place objects in the left and right 1 M and the front 2M, and do not have objects with strong reflection surfaces such as mirrors. Place...

3.Product Composition Start to charge . D Turn on the Master . Tum on the side power switch, "I" is the tum on, "O" is the tum off. After the master finishes working, it is recommended not to shut down; keep the master in a state of charge so that it can perform its next job better. ...

3.Product Composition Start Cleaning Start the Automatic Cleaning Mode with the master's @ key or remote control ®key [J D nnnn l!lll!lj OU LJ LJ Before starting the mode, make sure that the outer ring of the @ key is red/blue and the master is in the state of being awakened. If the master does not ...

3.Product Composition 3.3 Mode Selection In order to adapt to different ground conditions and achieve deeper clean, this product has a variety of cleaning modes, which can be selected by remote control as needed. The remote control can switch any mode directly. Before starting the mode, make sure th...

3.Product Composition Turbo Mode Robot will increase suction. Suitable for a very dirty floor or a thick carpet. Qrurbo mode cannot be accessed while using the mop cleaning method. Time and Date Settings 1. Programming the Time and Date a . Settings of current weekday: D In the standby mode, press t...

3.Product Composition 3.4 Use of Water Permeable Rag This product is equipped with a water tank assembly. After the cleaning work is completed, if there is a demand for mopping, the dust box can be replaced with a water tank assembly. For the cleaning method, please refer to the [Maintenance] sectio...

3.Product Composition 3.5Roller Brush Assembly Assembly Choices Roller brush assembly: Scratch the floor, sweep effectively. Set roller brush assembly : set the roller brush and cover the board and then press to lock. >> 16

4.Maintance 4.1 Dust Box and Filter When cleaning and maintaining the master and its accessories, turn off the master and unplug the charging stand. ■ Remove the dust box, open the dust box cover, and clean the garbage . )) STEP 01 ■ Remove dust filter. HEPA is not recommended for washing. Please pa...

4.Maintance 4.2 Water Tank Assembly Cleaning o f Water Rag ■ Remove: After the mopping is completed, remove the water tank assembly, and remove the water permeable rag. STEP 01 ■ Maintenance: Rinse and dry the water rag STEP 02 ■ Cleaning the Water Reservoir Remove: After mopping the floor, remove t...

4.Maintance 4.3 Rolling Brush, Side Brushes ■ Cleaning Rolling Brush Remove the rolling brush cover plate, remove the rolling brush, cut off the hair round on the rolling brush, and facilitate cleaning. STEP 01 ■ Cleaning Side Brushes Pull out the side brush and wipe it with a clean rag. STEP 02 19

5.Lighting Effects And Alarm Tips 5.1 Lighting Effects Cleaner status AUTO Disolav Status Cleaner stop cleaning Blue lamp light on Start auto charQe Purple &blue lamp liQht on Start to Spiral clean Blue lamp light on Start to wall follow cleanina Blue lamo liaht on Start recharQinQ Blue lamp fla...

5 Lighting Effects And Alarm Tips 5.2Alarm Tips When the host fails, the red light of the outer ring of the host key flashes, and the buzzer sounds of different lengths will be emitted. Refer to the following table to check the cause of the fault: Cleaner status Side brush error Fan motor error Main...

6.FAQ If the following problems occur during the use of the product, you can solve it yourself by checking the queries. No Cause of Falli.n, Probable Reasons Solution Make sure that the master is fully docked with the charging poles of the cradle. 01 When the master does not work, it is off and the ...

www.mygenieshop.com.au Consumer Warranty MyGenie would like you to enjoy your new purchase. This warranty card is provided to ensure that you get satisfaction . Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You are entitled to a replacement or refund for a maj...